FOREWORD
0 INTRODUCTION
1 SCOPE
2 NORMATIVE REFERENCES
3 DEFINITIONS
4 HAZARDS AND DANGER ZONES
    4.1 Hazards and danger zones relating to all
          units
    4.2 Specific hazards and danger zones relating to
          individual units
          4.2.1 Continuous Sheet Unwind Unit
          4.2.2 Single Sheet Feed Unit
          4.2.3 Material intake
          4.2.4 Conveying Equipment
          4.2.5 Heating, Pre-heating and Edge Heating
          4.2.6 Forming Station
          4.2.7 Finishing Station
          4.2.8 Stacking Station
          4.2.9 Discharge Station
          4.2.10 Residual Sheet Winding Unit
          4.2.11 Sheet Cutting Unit
5 Safety Requirements and/or Measures
    5.1 General Safety Requirements and/or Measures
          relating to all units
    5.2 Specific safety requirements and/or measures
          relating to individual units
          5.2.1 Continuous Sheet Unwind Unit
          5.2.2 Single Sheet Feed Unit
          5.2.3 Material intake
          5.2.4 Conveying Equipment
          5.2.5 Heating, Pre-heating and Edge Heating
          5.2.6 Forming Station
          5.2.7 Finishing Station
          5.2.8 Stacking zone
          5.2.9 Discharge Station
          5.2.10 Residual Sheet Winding Unit
          5.2.11 Sheet Cutting Unit
6 Verification of Conformity with the Safety Requirements
    and/or Measures
7 Information for use
ANNEX A (informative) Examples of thermoforming machines
ANNEX B (informative) Bibliography
ANNEX ZA (informative) Clauses of this European standard
         addressing essential requirements or other
         provisions of EU Directives