SN EN 61169-1 : 1994 AMD 2 1997

Cross-reference table of corresponding clauses in
publications 169-1 and 1169-1
1 Scope
2 Object
3 Normative references
4 Definitions
5 Units, symbols and dimensions
6 Standard ratings and characteristics
7 Classification into climatic categories
8 IEC type designation
9 Test Methods
9.1 General
9.1.1 Standard conditions for testing
9.1.2 Visual inspection
9.1.3 Dimensions
9.2 Electrical tests and measuring procedures
9.2.1 Reflection factor
9.2.2 Power rating
9.2.3 Contact resistance, outer conductor and screen
        continuity also centre conductor continuity
9.2.4 Centre and outer conductor contact continuity
        under severe mechanical conditioning
9.2.5 Insulation resistance
9.2.6 Voltage proof
9.2.7 Water immersion test
9.2.8 Screening effectiveness
9.2.9 Discharge test (corona test)
9.3 Mechanical tests and measuring procedures
9.3.1 General
9.3.2 Soldering, vibration, gauge retention force,
        effectiveness of contact
9.3.3 Vibration
9.3.4 Gauge retention force (resilient contacts)
9.3.5 Centre contact captivation
9.3.6 Engagement and separation forces and torques
9.3.7 Mechanical tests on cable fixing
9.3.8 Effectiveness of clamping device against cable
        pulling
9.3.9 Effectiveness of clamping device against cable
        bending
9.3.10 Effectiveness of clamping device against cable
        torsion
9.3.11 Strength of coupling mechanism
9.3.12 Bending moment (and shearing force)
9.3.13 Bump
9.3.14 Shock
9.4 Climatic conditions and tests
9.4.1 Introduction
9.4.2 Climatic sequence
9.4.3 Damp heat, steady state
9.4.4 Rapid change of temperature
9.4.5 Sealing
9.4.6 Salt mist
9.4.7 Dust
9.4.8 Sulphur dioxide test
9.4.9 Water
9.5 Mechanical endurance
9.6 High temperature endurance
9.7 Resistance to solvents and contaminating fluids
10 Quality assessment
10.1 General
10.2 Quality assessment procedures
10.3 Test and measurement procedures
10.4 Specifications and related procedures
11 Marking
11.1 Marking of the component
11.2 Marking and contents of package
Annexes
A Simulated sea-water solution for use with salt
        mist test
B Related documents
C Guidelines for the determination of tensile
        forces and torsional moments to be applied when
        testing the effectiveness pf cable retention with
        recommended values for some typical cables
ZA (normative) Other international publications
        quoted in this standard with the references of
        the relevant European publications