UNI EN ISO 13704 : 2009

Foreword
1 Scope
2 Terms and definitions
3 General design information
  3.1 Information required
  3.2 Limitations for design procedures
4 Design
  4.1 General
  4.2 Equation for stress
  4.3 Elastic design (lower temperatures)
  4.4 Rupture design (higher temperatures)
  4.5 Intermediate temperature range
  4.6 Minimum allowable thickness
  4.7 Minimum and average thicknesses
  4.8 Equivalent tube metal temperature
  4.9 Component fittings
5 Allowable stresses
  5.1 General
  5.2 Elastic allowable stress
  5.3 Rupture allowable stress
  5.4 Rupture exponent
  5.5 Yield and tensile strengths
  5.6 Larson-Miller parameter curves
  5.7 Limiting design metal temperature
  5.8 Allowable stress curves
6 Sample calculations
  6.1 Elastic design
  6.2 Thermal-stress check (for elastic range
      only)
  6.3 Rupture design with constant temperature
  6.4 Rupture design with linearly changing
      temperature
Annex A (informative) - Estimation of remaining
        tube life
Annex B (informative) - Calculation of maximum radiant
        section tube skin temperature
Annex C (normative) - Thermal-stress limitations
        (elastic range)
Annex D (informative) - Calculation sheets
Annex E (normative) - Stress curves (SI units)
Annex F (normative) - Stress curves (USC units)
Annex G (normative) - Derivation of corrosion fraction
        and temperature fraction
Annex H (informative) - Data sources
Bibliography