09/30214226 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
04-30-2011
English
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Additional requirements for the repair and overhaul
of equipment with type of protection "d" (flameproof)
6 Additional requirements for the repair and overhaul
of equipment with type of protection "i" (intrinsic
safety)
7 Additional requirements for the repair and overhaul
of equipment with type of protection "p" (pressurized)
8 Additional requirements for the repair and overhaul of
equipment with type of protection "e" (increased safety)
9 Additional requirements for the repair and overhaul of
equipment with type of protection "n" (non-sparking)
10 Additional requirements for the repair and overhaul of
equipment covered by IEC 60079-26
11 Additional requirements for the repair and overhaul of
equipment with type of protection Group III 't'
(formerly known as 'tD' or DIP)
12 Additional requirements for the repair and overhaul of
equipment with type of protection pressurization 'pD'
Annex A (normative) - Identification of repaired equipment
by marking
Annex B (normative) - Knowledge, skills and competencies of
"Responsible Persons" and "Operatives"
Annex C (normative) - Requirements for measurements in
flameproof equipment during overhaul, repair and
reclamation (including guidance on tolerances)
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.