14/30257552 DC : 0

Superseded

BS ISO 3245 - ROLLING BEARINGS - NEEDLE ROLLER BEARINGS, DRAWN CUP WITHOUT INNER RING - GEOMETRICAL PRODUCT SPECIFICATIONS (GPS), BOUNDARY DIMENSIONS AND TOLERANCES

Available format(s)

Hardcopy , PDF

Superseded date

01-31-2016

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Boundary dimensions
6 Tolerances
7 Measurement of the smallest bore diameter
of needle roller complement
Annex A (informative) - Tolerances for shaft
raceway and housing bore
Bibliography

BS ISO 3245.

Committee	MCE/7
DocumentType	Draft
Pages	18
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS ISO 3245:2015

ISO 2639:2002	Steels Determination and verification of the depth of carburized and hardened cases
ISO/TR 14638:1995	Geometrical product specification (GPS) Masterplan
ISO 8015:2011	Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules
ISO 1132-2:2001	Rolling bearings Tolerances Part 2: Measuring and gauging principles and methods
ISO 1101:2017	Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
ISO 5593:1997	Rolling bearings Vocabulary
ISO 14253-1:2017	Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications
ISO 1132-1:2000	Rolling bearings — Tolerances — Part 1: Terms and definitions
ISO 286-1:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits
ISO 15241:2012	Rolling bearings — Symbols for physical quantities
ISO 286-2:2010	Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO 14405-1:2016	Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes
ISO 14253-2:2011	Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification
ISO 10579:2010	Geometrical product specifications (GPS) Dimensioning and tolerancing Non-rigid parts