BS ISO 17902 - WRAPPED ELECTROFOAMING JOINTS FOR PE PIPING SYSTEMS WITH SMOOTH OUTER WALL FOR GRAVITY DRAINS AND SEWERS

Available format(s)

Hardcopy , PDF

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Material
5 General requirements
6 Geometrical characteristics
7 Mechanical characteristics
8 Performance requirements
9 Marking
Annex A (Informative) - Wrapped electrofoaming joint
joining procedure guide

BS ISO 17902.

Committee	PRI/88/1
DocumentType	Draft
Pages	20
PublisherName	British Standards Institution
Status	NA

ISO 13953:2001	Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
ISO 13263:2010	Thermoplastics piping systems for non-pressure underground drainage and sewerage Thermoplastics fittings Test method for impact strength
ISO 1167-2:2006	Thermoplastics pipes, fittings and assemblies for the conveyance of fluids — Determination of the resistance to internal pressure — Part 2: Preparation of pipe test pieces
ISO 8772:2006	Plastics piping systems for non-pressure underground drainage and sewerage Polyethylene (PE)
ISO 1133-1:2011	Plastics Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics Part 1: Standard method
ISO 3126:2005	Plastics piping systems Plastics components Determination of dimensions
ISO 21138-2:2007	Plastics piping systems for non-pressure underground drainage and sewerage Structured-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) Part 2: Pipes and fittings with smooth external surface, Type A
ISO 13272:2011	Plastics piping systems for non-pressure underground drainage and sewerage — Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP), polypropylene with mineral modifiers (PP-MD) and polyethylene (PE) — Specifications for manholes and inspection chambers in traffic areas and underground installations
ISO 472:2013	Plastics Vocabulary
ISO 1183-1:2012	Plastics Methods for determining the density of non-cellular plastics Part 1: Immersion method, liquid pyknometer method and titration method
ISO 1872-2:2007	Plastics Polyethylene (PE) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties
ISO 11357-6:2008	Plastics Differential scanning calorimetry (DSC) Part 6: Determination of oxidation induction time (isothermal OIT) and oxidation induction temperature (dynamic OIT)
ISO 21138-1:2007	Plastics piping systems for non-pressure underground drainage and sewerage Structured-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE) Part 1: Material specifications and performance criteria for pipes, fittings and system
ISO 1043-1:2011	Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics
ISO 1167-1:2006	Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 1: General method