BS EN ISO 11297-4 - PLASTICS PIPING SYSTEMS FOR RENOVATION OF UNDERGROUND DRAINAGE AND SEWERAGE NETWORKS UNDER PRESSURE - PART 4: LINING WITH CURED-IN-PLACE PIPES

Available format(s)

Hardcopy , PDF

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Pipes at the 'M' stage
6 Fittings at the 'M' stage
7 Ancillary components
8 Fitness for purpose of the installed lining system
at the 'I' stage
9 Installation practice

BS EN ISO 11297-4.

Committee	PRI/88/3
DocumentType	Draft
Pages	21
PublisherName	British Standards Institution
Status	NA

ISO 8521:2009	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Test methods for the determination of the apparent initial circumferential tensile strength
ISO 7432:2002	Glass-reinforced thermosetting plastics (GRP) pipes and fittings Test methods to prove the design of locked socket-and-spigot joints, including double-socket joints, with elastomeric seals
ISO 7685:1998	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of initial specific ring stiffness
ISO 10928:2016	Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use
ISO 11295:2017	Classification and information on design and applications of plastics piping systems used for renovation and replacement
ISO 75-2:2013	Plastics — Determination of temperature of deflection under load — Part 2: Plastics and ebonite
ISO 13002:1998	Carbon fibre Designation system for filament yarns
ISO 8533:2003	Plastics piping systems for pressure and non-pressure drainage and sewerage Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin Test methods to prove the design of cemented or wrapped joints
ISO 8513:2016	Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes — Test methods for the determination of the initial longitudinal tensile strength
ISO 10468:2003	Glass-reinforced thermosetting plastics (GRP) pipes Determination of the long-term specific ring creep stiffness under wet conditions and calculation of the wet creep factor
ISO 7684:1997	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of the creep factor under dry conditions
ISO 11297-1:2013	Plastics piping systems for renovation of underground drainage and sewerage networks under pressure Part 1: General
ISO 10952:2014	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes and fittings Determination of the resistance to chemical attack for the inside of a section in a deflected condition
ISO 178:2010	Plastics Determination of flexural properties
ISO 7509:2015	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of time to failure under sustained internal pressure