ANSI DRAFT C63.17 : D3.5 2006

1 Introduction
  1.1 SCOPE
  1.2 APPLICATIONS
  1.3 ROADMAP TO THE DOCUMENT
2 Normative references
3 Definitions, acronyms and abbreviations
  3.1 DEFINITIONS
  3.2 ACRONYMS AND ABBREVIATIONS
4 Radiated and conducted emissions test methodology
  4.1 TEST FACILITIES AND EQUIPMENT
  4.2 TEST CONFIGURATIONS AND SETUP
  4.3 TRANSMITTED POWER AND MONITORING THRESHOLD LIMITS
       4.3.1 Peak transmit power
       4.3.2 Peak transmit power spectral density
       4.3.3 Upper monitoring threshold
       4.3.4 Lower monitoring threshold
  4.4 LIMITS FOR RADIATED AND CONDUCTED TESTS
  4.5 CONDUCTED MEASUREMENTS OF PRODUCTS WITH IDENTICAL
       COLLOCATED TRANSMITTING AND MONITORING ANTENNAS
  4.6 CONDUCTED MEASUREMENTS OF PRODUCTS WITH COLLOCATED
       TRANSMITTING AND MONITORING ANTENNAS OF DIFFERENT TYPES
  4.7 CONDUCTED MEASUREMENTS OF PRODUCTS WITH ARBITRARILY
       PLACED TRANSMITTING AND MONITORING ANTENNAS
  4.8 RADIATED MEASUREMENTS OF PRODUCTS WITH IDENTICAL
       COLLOCATED TRANSMITTING AND MONITORING ANTENNAS
  4.9 RADIATED MEASUREMENTS OF PRODUCTS WITH COLLOCATED
       TRANSMITTING AND MONITORING ANTENNAS OF DIFFERENT TYPES
  4.10 RADIATED MEASUREMENTS OF PRODUCTS WITH ARBITRARILY
       PLACED TRANSMITTING AND MONITORING ANTENNAS
  4.11 MANUFACTURER'S DECLARATIONS AND DESCRIPTIONS
5 Measurement instrumentation
  5.1 MULTI-CARRIER INTERFERENCE GENERATOR
  5.2 ALTERNATIVE INSTRUMENTATION
6 RF measurements
  6.1 EMISSIONS TESTS
      6.1.1 Test requirements
      6.1.2 Peak transmit power
      6.1.3 Emission bandwidth B
      6.1.4 Modulation
      6.1.5 Power spectral density PSD[EUT] using the measured
            maximum method
      6.1.6 Emissions
  6.2 FREQUENCY AND TIME STABILITY
      6.2.1 Carrier frequency stability
      6.2.2 Frame-repetition stability
      6.2.3 Frame period and jitter
7 Monitoring tests
  7.1 INTRODUCTION
      7.1.1 Monitoring test set-up
      7.1.2 Monitoring test procedure - general
      7.1.3 Standard test frequencies
      7.1.4 Timeslot and carrier equivalence
  7.2 CALIBRATION OF LEVELS
      7.2.1 Calculation of thresholds
      7.2.2 Calibration of test interference field strength
            (radiated technique)
      7.2.3 Procedures for using out-of-operating region
            interference
  7.3 DEFERRAL THRESHOLDS AND CHANNEL SELECTION
      7.3.1 Lower threshold for EUTs which do not implement
            the LIC procedure
      7.3.2 Upper threshold for EUTs which implement the
            LIC procedure
      7.3.3 Least interfered channel (LIC) procedure test
      7.3.4 Selected channel confirmation
  7.4 THRESHOLD MONITORING BANDWIDTH
      7.4.1 Simple compliance test
      7.4.2 More detailed test
  7.5 REACTION TIME AND MONITORING INTERVAL
8 Time and spectrum window access procedure
  8.1 TIMING FOR EUTS USING CONTROL AND SIGNALING CHANNEL TYPE
      TRANSMISSIONS
      8.1.1 Access criteria test interval
      8.1.2 Access criteria functional test (47CFR15.323(c)(6)
            option not implemented)
      8.1.3 Access criteria functional test (47CFR15.323(c)(6)
            option implemented)
  8.2 TIMING FOR EUTS USING COMMUNICATIONS CHANNEL TYPE
      TRANSMISSIONS
      8.2.1 Acknowledgements
      8.2.2 Transmission duration
  8.3 DUPLEX CONNECTIONS
      8.3.1 Validation of dual access criteria check for
            EUTs which do not implement the upper threshold
      8.3.2 Validation of dual access criteria check for
            EUTs which implement the upper threshold
  8.4 ALTERNATIVE MONITORING INTERVAL
9 Test report
  9.1 TEST REPORT CONTENTS
  9.2 APPLICABLE STANDARDS
  9.3 EQUIPMENT UNITS TESTED
  9.4 TEST CONFIGURATION
  9.5 LIST OF TEST EQUIPMENT
  9.6 UNITS OF MEASUREMENT
  9.7 LOCATION OF TEST SITE
  9.8 MEASUREMENT PROCEDURES
  9.9 REPORTING MEASUREMENT DATA
  9.10 GENERAL AND SPECIAL CONDITIONS
  9.11 SUMMARY OF RESULTS
  9.12 REQUIRED SIGNATURES
  9.13 TEST REPORT APPENDIXES
  9.14 TEST REPORT DISPOSITION
Annex A
Annex B
      B.1 GENERAL
          B.1.1 DETACHABLE ANTENNAS
          B.1.2 NONDETACHABLE ANTENNAS
          B.1.3 ALTERNATIVE TEST FACILITIES, MEASUREMENT
                TECHNIQUES, AND TEST SITE VALIDATION
      B.2 POWER LIMITS
          B.2.1 TRANSMIT POWER LIMITS
          B.2.2 MONITORING THRESHOLD LIMITS
          B.2.3 EIRP AND ELECTRIC FIELD (E-FIELD) THRESHOLD
                LIMITS FOR RADIATED TESTS
          B.2.4 SEPARATE TRANSMIT AND MONITORING ANTENNAS
      B.3 TRANSMIT POWER AND MONITORING THRESHOLD TEST METHOD
          SELECTION
          B.3.1 DETACHABLE TRANSMIT AND MONITORING ANTENNAS
          B.3.2 NON-DETACHABLE TRANSMIT AND MONITORING ANTENNAS
                B.3.2.1 RELATIONSHIPS FOR RADIATED MEASUREMENT
                        OF EIRP
      B.4 GENERAL GUIDELINES ON MEASUREMENT CONDITIONS AND
          PROCEDURES
          B.4.1 CONDUCTED MEASUREMENTS
          B.4.2 RADIATED MEASUREMENTS
Annex C
      C.1 GENERAL
          C.1.1 THE MULTI-CARRIER SIGNAL GENERATOR
                C.1.1.1 TRIGGER FUNCTIONALITY FOR THE ARBITRARY
                        WAVEFORM GENERATOR FRAME SYNCHRONIZATION
                C.1.1.2 TRIGGER FUNCTIONALITY FOR THE ARBITRARY
                        WAVEFORM GENERATOR ON INTERFERENCE
                        PROFILE CHANGES
          C.1.2 EUT AND COMPANION DEVICE PROVISIONS
          C.1.3 INTERFACE ELEMENT
          C.1.4 SOFTWARE
      C.2 ALTERNATIVE APPROACHES