Foreword
Introduction
1 Scope
2 Normative references
   2.1 Approved references
   2.2 References under development
   2.3 Other references
3 Definitions, abbreviations, and conventions
   3.1 Definitions and abbreviations
   3.2 Conventions
4 General operational requirements
5 I/O register descriptions
6 Command descriptions
7 Parallel interface physical and electrical requirements
8 Parallel interface signal assignments and descriptions
9 Parallel interface general operating requirements
   of the physical, data link, and transport layers
10 Parallel interface register addressing
11 Parallel interface transport Protocols
12 Parallel interface timing
13 Serial interface general overview
   13.1 Overview
   13.2 Sub-module operation
   13.3 Parallel ATA Emulation (Optional)
14 Serial interface physical layer
   14.1 Overview
   14.2 Connectors specifications
   14.3 Cable assemblies
   14.4 Phy (Physical layer electronics)
   14.5 Electrical features
   14.6 Elasticity buffer management
   14.7 BIST (Built in self test)
15 Serial interface Link layer
   15.1 Overview
   15.2 Encoding method
   15.3 Transmission Method
   15.4 Primitives
   15.5 CRC calculation
   15.6 Scrambling
   15.7 Link layer state diagrams
16 Serial interface Transport layer
   16.1 Transport layer overview
   16.2 Frame Information Structure (FIS)
   16.3 Overview
   16.4 Payload content
   16.5 FIS types
   16.6 Host transport states
   16.7 Device transport states
17 Serial interface Device Command Layer Protocol
   17.1 COMRESET or SRST sent by Host
   17.2 Power-on and COMRESET protocol diagram
   17.3 Device Idle protocol
   17.4 Software reset protocol
   17.5 EXECUTE DEVICE DIAGNOSTIC command protocol
   17.6 DEVICE RESET command protocol
   17.7 Non-data command protocol
   17.8 PIO data-in command protocol
   17.9 PIO data-out command protocol
   17.10 DMA data-in command protocol
   17.11 DMA data out command protocol
   17.12 PACKET protocol
   17.13 READ DMA QUEUED command protocol
   17.14 WRITE DMA QUEUED command protocol
18 Host command layer state diagram
   18.1 Overview
   18.2 Device Emulation of nIEN with Interrupt Pending
         (Informative)
19 Serial interface host adapter register interface
   19.1 Overview
   19.2 SStatus, SError and SControl registers
20 Serial interface error handling
   20.1 Architecture
   20.2 Phy error handling overview
   20.3 Link error handling overview
   20.4 Transport error handling
Annexes
A Bibliography
B Command Set Summary
C Design and Programming Considerations for
  Large Physical Sector Sizes
D Device Determination of Cable Type
E Signal Integrity and UDMA Guide
F Register Selection Address Summary
G Sample Code for Serial CRC Scrambling
  G.1 CRC calculation
  G.2 Scrambling calculation
  G.3 Example frame
H FIS Type Field Value Selection
  H.1 Overview
  H.2 Type field values
I Physical Layer Implementation Examples
  I.1 Cable construction example
  I.2 Contact material and plating
  I.3 Relationship of frequency to the jitter
      specification
  I.4 Sampling BER and jitter formulas
  I.5 DC and AC coupled transmitter examples
  I.6 OOB signal and squelch detector examples
J Command Processing Example
  J.1 Non-data commands
Tables
Figures