Standard Specification for Nickel-Molybdenum Alloy Plate, Sheet, and Strip

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

11-01-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 02.04, 2015 Defines plate, sheet, and strip of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624) for use in general corrosive service.

1.1This specification2 covers plate, sheet, and strip of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624)3 as shown in Table 1, for use in general corrosive service.

1.2The following products are covered under this specification:

1.2.1Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

1.2.2Plate—Hot or cold rolled, solution annealed, and descaled.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	B 02
DocumentType	Standard
Pages	3
ProductNote	Reconfirmed 2003
PublisherName	American Society for Testing and Materials
Status	Current
SupersededBy	ASTM B 333 : 1998
Supersedes	ASTM B 333 : 2003 : R2013 ASTM B 333 : 1998

ASTM B 906 : 2022	Standard Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip
ASTM E 112 : 2013 : R2021	Standard Test Methods for Determining Average Grain Size
ASTM E 112 : 2013	Standard Test Methods for Determining Average Grain Size