Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with an Integral Wearing Surface

Available format(s)

PDF

Language(s)

English

Published date

02-06-2015

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 04.07, 2015 Specifies the design and installation of cold liquid-applied elastomeric waterproofing membrane systems that have an integral wearing surface.

1.1This guide describes the design and installation of cold liquid-applied elastomeric waterproofing membrane systems that have an integral wearing surface. The cold liquid-applied elastomeric waterproofing membrane (membrane) to which this guide refers is specified in Specification C957.

1.2Concrete Slab-on-Grade—Waterproofing the upper surface of a concrete slab on grade presents special problems due to the possibility of negative hydrostatic pressure causing loss of bond to the substrate. Consideration of these problems is beyond the scope of this guide. Consult the membrane manufacturer for recommendations when this situation exists.

1.3The committee having jurisdiction for this guide is not aware of any similar ISO standard.

1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see 15.4.

Committee	D 08
DevelopmentNote	Supersedes ASTM C 1127. (02/2015)
DocumentType	Redline
Pages	13
PublisherName	American Society for Testing and Materials
Status	Current

ASTM C 962 : 86 E1	GUIDE FOR USE OF ELASTOMERIC JOINT SEALANTS
ASTM C 1193 : 2016 : REDLINE	Standard Guide for Use of Joint Sealants
ASTM C 332 : 2017 : REDLINE	Standard Specification for Lightweight Aggregates for Insulating Concrete
ASTM C 330 : 2005	Standard Specification for Lightweight Aggregates for Structural Concrete
ASTM D 653 : 2014 : REDLINE	Standard Terminology Relating to Soil, Rock, and Contained Fluids