• There are no items in your cart

ASTM D 2852 : 1995 : R2002

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
Superseded date

11-11-2014

Published date

09-10-1995

CONTAINED IN VOL. 10.01, 2017 Defines determination of the thermal endurance of film-insulated round magnet wire in air at atmospheric pressure.

1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, impact resistance, load-deflection properties, dimensional stability, and joint tightness of plain-end or bell-end styrene-rubber (SR) plastic drain pipe and fittings in sizes 2 through 6 in.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
F 17
DocumentType
Standard
ProductNote
Reconfirmed 2002 Reconfirmed EV A
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM D 3122 : 2015 Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings
ASTM F 810 : 2012 : R2018 Standard Specification for Smoothwall Polyethylene (PE) Pipe for Use in Drainage and Waste Disposal Absorption Fields

ASTM D 1711 : 2015 : REDLINE Standard Terminology Relating to Electrical Insulation
IEC 60172:2015 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires
IEEE 101 : 1987 GUIDE FOR THE STATISTICAL ANALYSIS OF THERMAL LIFE TEST DATA
ASTM D 5423 : 2014 Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.