ASTM D 2974 : 2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
03-12-2020
English
11-01-2014
1.1These test methods cover the measurement of moisture content, ash content, and organic matter in peats and other organic soils, such as organic clays, silts, and mucks. Test Method D2216 provides an alternative method for determining moisture content in mineral soils and rock.
1.1.1Test Method A—Moisture is determined by drying peat or organic sample at 110 ± 5°C.
1.1.2Test Method B—Alternative moisture method which removes the total moisture in two steps: (1) evaporation of moisture at room temperature, (2) subsequent oven drying of air dried sample at 110 ± 5°C. This method is used when the peat is to be used as fuel.
1.1.3Test Method C—Ash content of a peat or organic soil sample, for general purposes, is determined by igniting oven dried sample from moisture content determination in a furnace at 440 ± 40°C.
1.1.4Test Method D—Ash content of a peat or organic soil sample, for materials used for fuel, is determined by igniting oven dried sample from moisture content determination in a furnace at 750 ± 38°C.
1.2Test Method A should be used for general classification, except for use of the peat as a fuel. Test Method B should be used when peats are being evaluated for use as a fuel
1.3The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.4All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026.
1.4.1The procedures used to specify how data are collected/recorded or calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that generally should be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations. It is beyone the scope of this standard to consider significant digits used in analysis methods for engineering design.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.