Standard Test Method for Flexural Properties of Fiber Reinforced Pultruded Plastic Rods

Available format(s)

PDF

Language(s)

English

Published date

05-01-2014

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 08.03, 2014 Defines the determination of the flexural properties of fiber-reinforced pultruded plastic rods.

1.1This test method covers the determination of the flexural properties of fiber-reinforced pultruded plastic rods. The specimen is a rod with a semicircular cross section, molded or cut from lengths of pultruded rods (see Fig. 1). This test method is designed for rods with a diameter of ¹/₂in. or greater.

Note 1—There is no known ISO equivalent to this standard.

FIG. 1 Cross Section of Test Specimen

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	D 20
DevelopmentNote	Supersedes ASTM D 4476. (06/2014)
DocumentType	Redline
Pages	7
PublisherName	American Society for Testing and Materials
Status	Current

ASTM D 618 : 2013 : REDLINE	Standard Practice for Conditioning Plastics for Testing
ASTM D 3918 : 2011 : REDLINE	Standard Terminology Relating to Reinforced Plastic Pultruded Products