Standard Test Method for Measurement of Properties of Thermoplastic Materials by Screw-Extrusion Capillary Rheometer

Available format(s)

PDF

Language(s)

English

Published date

01-26-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 08.03, 2018 Defines the use of a screw-extrusion type capillary rheometer for the measurement of flow properties of thermoplastics and thermoplastic compounds.

1.1This test method covers the use of a screw-extrusion-type capillary rheometer for the measurement of flow properties of thermoplastics and thermoplastic compounds. The measured flow properties, which are obtained through laboratory investigation, may help to describe the material behavior that occurs in factory processing.

1.2Since a screw-type capillary rheometer imparts shear energy to the material during testing, the measurements will usually differ from those obtained with a piston-type capillary rheometer (see Test Method D3835).

1.3Capillary rheometer measurements for thermoplastics and thermoplastic compounds are described in Test Method D3835.

1.4The values stated in SI units are to be regarded as standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:There is no known ISO equivalent to this standard. The scope of this standard is mentioned in ISO 11443:2014, Plastics—Determination of the fluidity of plastics using capillary and slit-die rheometers,” Annex C, “Uncertainties in the determination of shear viscosity by capillary extrusion.”

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 20
DocumentType	Redline
Pages	10
PublisherName	American Society for Testing and Materials
Status	Current

ASTM D 618 : 2013 : REDLINE	Standard Practice for Conditioning Plastics for Testing
ASTM D 1238 : 2013 : REDLINE	Standard Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer
ASTM D 3835 : 2016 : REDLINE	Standard Test Method for Determination of Properties of Polymeric Materials by Means of a Capillary Rheometer