Standard Test Method for Determination of Total Sulfur in Liquid Hydrocarbons and Hydrocarbon-Oxygenate Blends by Gas Chromatography with Flame Photometric Detection

Available format(s)

PDF

Language(s)

English

Published date

04-18-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 05.04, 2017 Specifies the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450 degrees C by gas chromatography using a flame photometric detector.

1.1This test method covers the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450 °C by gas chromatography using a flame photometric detector.

1.2This test method is applicable for total sulfur levels from 0.5 mg S/kg to 100 mg S/kg.

Note 1:The pooled limit of quantification (PLOQ) derived from the 2002 interlaboratory cooperative test program was determined to be 1 mgS/kg.

Note 2:Samples can also be tested at other total sulfur levels, but the precision statements may not apply.

1.3The values stated in SI units are to be regarded as standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7.

Committee	D 02
DocumentType	Redline
Pages	6
PublisherName	American Society for Testing and Materials
Status	Current

ASTM D 7578 : 2015-06	GUIDE FOR CALIBRATION REQUIREMENTS FOR ELEMENTAL ANALYSIS OF PETROLEUM PRODUCTS AND LUBRICANTS
ASHRAE HDBK REFRIGERATION : 2014	ASHRAE HANDBOOK - REFRIGERATION