Standard Specification for Emulsified Asphalt Used as a Protective Coating for Roofing

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

05-01-2019

Publisher

American Society for Testing and Materials

This specification covers emulsified asphalt suitable for use as a protective coating for built-up roofs and other exposed surfaces with inclines of not less than 4 % or 42 mm/m [1/2 in./ft].

1.1This specification covers emulsified asphalt suitable for use as a protective coating for built-up roofs and other exposed surfaces with inclines of not less than 4 % or 42 mm/m [¹/₂in./ft].

1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 08
DocumentType	Standard
Pages	2
ProductNote	ε1 NOTE—Units information was editorially corrected in May 2019.
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 1227 : 2013

ASTM D 2939 : 2003	Standard Test Methods for Emulsified Bitumens Used as Protective Coatings (Withdrawn 2012)
ASTM D 2939 : 1998	Standard Test Methods for Emulsified Bitumens Used as Protective Coatings