Standard Practice for Preparation of Disk Specimens of Steel and Iron by Remelting for Spectrochemical Analysis

Available format(s)

PDF

Language(s)

English

Published date

01-15-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 03.05, 2016 Specifies the preparation of disk specimens of iron and steel by melting chips, chunks, drillings, turnings, wire, or powder briquets with an electric arc in an argon atmosphere.

1.1This practice describes the preparation of disk specimens of steel and iron by melting chunks, chips, drillings, turnings, wire, or powder briquets with an electric arc in an argon atmosphere. Solidification of the specimen takes place in the crucible in an argon atmosphere. The disk obtained is suitable for quantitative spectrochemical analysis.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 6.2.1, Section 8, and 10.1.2.1.

Committee	E 01
DocumentType	Redline
Pages	7
PublisherName	American Society for Testing and Materials
Status	Current

MIL-E-23765-2 Revision E:1994	ELECTRODES AND RODS - WELDING, BARE, SOLID OR ALLOYED CORED, LOW ALLOY STEEL
ASTM E 1806 : 2009	Standard Practice for Sampling Steel and Iron for Determination of Chemical Composition
ASTM E 1806 : 2009 : R2016	Standard Practice for Sampling Steel and Iron for Determination of Chemical Composition