ASTM F 2503 : 2020
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
11-08-2023
English
03-04-2020
1.1This international standard applies to the practice of marking of items that might be used in the magnetic resonance (MR) environment.
1.2The purpose of this practice is to mark items that might be brought into the MR environment and to recommend information that should be included in the marking.
1.3The standard specifies the permanent marking of items, which are used in an MR environment, by means of terms and icons.
1.4MR image artifacts are not considered to be a performance issue and so are not addressed in this international standard practice (see X1.5).
1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.