Name: ASTM G 110 : 1992 : R2009
Brand: ASTM
Price: 66.00 USD

ASTM G 110 : 1992 : R2009

Superseded

Standard Practice for Evaluating Intergranular Corrosion Resistance of Heat Treatable Aluminum Alloys by Immersion in Sodium Chloride + Hydrogen Peroxide Solution

Available format(s)

Hardcopy , PDF

Superseded date

11-11-2014

Language(s)

English

Published date

05-01-2009

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 03.02, 2016 Defines the procedures for immersion tests in sodium chloride + hydrogen peroxide solution.

1.1 This practice covers the procedures for immersion tests in sodium chloride + hydrogen peroxide solution. It is primarily for tests of wrought heat treatable aluminum alloys (2XXX and 7XXX) but may be used for other aluminum alloys, including castings. It sets forth the specimen preparation procedures and the environmental conditions of the test and the means for controlling them.

1.2 This practice is intended for evaluations during alloy development and for evaluating production where it may serve as a control test on the quality of successive lots of the same material (see MIL-H-6088 and U.S. Federal Test Method Std. 151b). Therefore strict test conditions are stipulated for maximum assurance that variations in results are attributable to lot-to-lot differences in the material being tested.

Note 1—This practice does not address sampling or interpretation or significance of results.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee	G 01
DocumentType	Standard Practice
Pages	3
ProductNote	Reconfirmed 2009
PublisherName	American Society for Testing and Materials
Status	Superseded
SupersededBy	ASTM G 110 : 1992 : R2015
Supersedes	ASTM G 110 : 1992 : R2003 : EDT 1

ASTM G 67 : 2013	Standard Test Method for Determining the Susceptibility to Intergranular Corrosion of 5XXX Series Aluminum Alloys by Mass Loss After Exposure to Nitric Acid (NAMLT Test)
ASTM G 69 : 2012 : REDLINE	Standard Test Method for Measurement of Corrosion Potentials of Aluminum Alloys
MIL-H-6088 Revision G:1991	HEAT TREATMENT OF ALUMINIUM ALLOYS