BS 1211:1958
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Specification for centrifugally cast (spun) iron pressure pipes for water, gas and sewage
Hardcopy , PDF
08-02-2013
English
02-24-1958
Co-operating organizations
Foreword
Specification
Section one: General
1 Scope
2 General
3 Quality of metal used in casting pipes
4 Quality control
5 Selection of test pieces by the purchaser
6 Mechanical tests
7 Hydraulic tests
8 Test for straightness and uniformity
9 Tolerances on dimensions of pipes
10 Gauging
11 Freedom from defects
12 Coating
13 Weighing and marking weights
14 Permissible deviation from standard weights
15 Inspection
16 Manufacturer's certificate
17 Testing facilities
Section two: Special conditions applicable to pipes
centrifugally cast in metal moulds
18 General
19 Heat treatment
20 Tensile ring test
21 Tensile bar test
22 Brinell test
23 Marking
Section three: Special conditions applicable to pipes
centrifugally cast in sand moulds
24 General
25 Mode of casting
26 Removal from moulds
27 Tensile ring test
28 Tensile bar test
29 Marking
Section four: Standard 'spun' iron spigot and socket
pipes for water, gas and sewage metal spun
and sand spun
Table 8 Standard thicknesses, external diameter and
weight per foot of barrel
Table 9 Standard weights
Table 10 Dimensions of standard spigots and sockets
Appendices
A Typical rig for tensile ring test
B Dimensions of tensile bar test pieces
C Conversion factors
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.