BS EN 12807:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
LPG equipment and accessories. Transportable refillable brazed steel cylinders for liquefied petroleum gas (LPG). Design and construction
Hardcopy , PDF
07-19-2019
English
06-30-2009
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
3.1 Terms and definitions
3.2 Symbols
4 Materials
5 Design
5.1 General requirements
5.2 Calculation of cylindrical shell thickness
5.3 Design of torispherical and semi-ellipsoidal ends
concave to pressure
5.4 Design of ends of shapes other than torispherical
and semi-ellipsoidal
5.5 Minimum wall thickness
5.6 Design of openings
5.7 Valve protection
5.8 Non-pressure containing attachments
6 Construction and workmanship
6.1 Brazing qualification
6.2 Plates and pressed parts
6.3 Brazed joints
6.4 Tolerances
6.4.1 Out of roundness
6.4.2 Straightness
6.4.3 Verticality
6.5 Heat treatment
6.6 Protective coating
6.7 Closure of openings
7 Tests and examinations
7.1 General
7.2 Types of test and evaluation of the test results
7.3 Material testing
7.4 Tensile test
7.4.1 Parent material
7.4.2 Joints
7.5 Bend test
7.5.1 Procedure
7.5.2 Requirements
7.6 Burst test under hydraulic pressure
7.6.1 Procedure
7.6.2 Requirements
7.7 Pressure test
7.7.1 Procedure
7.7.2 Requirements
7.8 Ultrasonic examination
7.8.1 Procedure
7.8.2 Assessment
7.8.3 Requirements
7.9 Macro examination
7.9.1 Procedure
7.9.2 Requirements
7.10 Visual examination of the surface of the joint
7.10.1 Procedure
7.10.2 Requirements
7.11 Fatigue test
7.11.1 Procedure
7.11.2 Requirement
8 Technical requirements for type approval
8.1 Extent of testing
8.2 Cylinder types
8.3 Type approval certificate
9 Production testing and examination requirements
9.1 Tests and examinations applicable to all cylinders
9.2 Ultrasonic examination
9.3 Macro examination
9.4 Examination of the valve boss joint
9.5 Examination of non-pressure containing joints
9.6 Unacceptable imperfections found by the ultrasonic or
macro examinations
9.7 Batch testing (Mechanical/Burst tests)
9.7.1 Batch
9.7.2 Inspection lots
9.7.3 Rate of sampling
9.7.4 Additional checks
9.8 Failure to meet mechanical and burst test requirements
9.8.1 Mechanical
9.8.2 Burst
9.8.3 Re-test
9.8.4 Resubmission of an inspection lot
10 Marking
11 Certificates
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.