Defines heat pumps for space heating, heat pump water heaters (HPWH) and heat pumps with combined space heating and domestic hot water production in alternate or simultaneous operation, where the same heat pump delivers the heat to cover the space heating and domestic hot water heat requirement.

This European Standard covers heat pumps for space heating, heat pump water heaters (HPWH) and heat pumps with combined space heating and domestic hot water production in alternate or simultaneous operation, where the same heat pump delivers the heat to cover the space heating and domestic hot water heat requirement. The standard provides a calculation method under steady conditions that corresponds to one calculation step. The results of this calculation are incorporated in larger building models and take in account the influence of the external conditions and building control that influence the energy requirements for heating supplied by the heat pump system. The scope of this part is to standardize the: required inputs; calculation methods; required outputs Generation for space heating and domestic hot water production of the following heat pump systems, including control of: electrically-driven vapour compression cycle (VCC) heat pumps; combustion engine-driven vapour compression cycle heat pumps; thermally-driven vapour absorption cycle (VAC) heat pumps, using combinations of heat source and heat distribution listed in Table 1. Table 1 — Heating sources and energy distribution Source Distribution Outdoor air Water Exhaust-air Indirect ground source with brine Indirect ground source with water Direct ground source (Direct expansion (DX) Surface water Ground water This standard does not cover sizing or inspection of heat pumps. This standard deals with heat generators for heating or for combined domestic hot water and heating service. Generators for domestic hot water only are taken into account into module M8-8. NOTE 1 Heat pumps for cooling systems are taken into account into module M4–8. NOTE 2 Heat pumps for space heating using air (distribution) are taken into account in module M5–8. Other generation systems such as boilers are covered in other sub modules of part M3-8. This is the revision of EN 15316-4-2:2008. The revision covers the adaptation of the standard to hourly and monthly energy calculation. Table 2 shows the relative position of this standard within the set of EPB standards in the context of the modular structure as set out in EN ISO 52000-1. NOTE 3 In CEN ISO/TR 52000-2 the same table can be found, with, for each module, the numbers of the relevant EPB standards and accompanying technical reports that are published or in preparation. NOTE 4 The modules represent EPB standards, although one EPB standard may cover more than one module and one module may be covered by more than one EPB standard, for instance a simplified and a detailed method respectively. See also Clause 2 and Tables A.1 and B.1. Table2 — Position of this standard, within the modular structure of the set of EPB standards Overarching Building (as such) Technical Building Systems Descriptions Descriptions Descriptions Heating Cooling Ventilation Humidification Dehumidification Domestic Hot water Lighting Building automation and control Electricity production sub1 M1 sub1 M2 sub1 M3 M4 M5 M6 M7 M8 M9 M10 M11 1 General 1 General 1 General 15316–1 15316–1 2 Common terms and definitions; symbols, units and subscripts 2 Building Energy Needs 2 Needs 12831–3 ? 3 Applications 3 (Free) Indoor Conditions without Systems 3 Maximum Load and Power 12831–1 12831–3 4 Ways to Express Energy Performance 4 Ways to Express Energy Performance 4 Ways to Express Energy Performance 15316–1 15316–1 5 Building Functions and Building Boundaries 5 Heat Transfer by Transmission 5 Emission and control 15316–2 15316–2 6 Building Occupancy and Operating Conditions 6 Heat Transfer by Infiltration and Ventilation 6 Distribution and control 15316–3 15316–3 15316–3 7 Aggregation of Energy Services and Energy Carriers 7 Internal Heat Gains 7 Storage and control 15316–5 15316–515316–4-3 8 Building Partitioning 8 Solar Heat Gains 8 Generation 8–1 Combustion boilers 15316–4-1 15316–4-1 8–2 Heat pumps 15316–4-2 15316–4-2 8–3 Thermal solar Photovoltaics 15316–4-3 15316–4-3 15316–4-3 8–4 On-site cogeneration 15316–4-4 15316–4-4 15316–4-4 8–5 District heating and cooling 15316–4-5 15316–4-5 15316–4-5 8–6 Direct electrical heater 15316–4-6 15316–4-6 8–7 Wind turbines 15316–4-7 8–8 Radiant heating, stoves 15316–4-8 9 Calculated Energy Performance 9 Building Dynamics (thermal mass) 9 Load dispatching and operating conditions 10 Measured Energy Performance 10 Measured Energy Performance 10 Measured Energy Performance 15378–3 15378–3 11 Inspection 11 Inspection 11 Inspection 15378–1 15378–1 12 Ways to Express Indoor Comfort 12 – 12 BMS