INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirement
5 General conditions for the tests
6 Classification
7 Marking and instructions
8 Protection against access to live parts
9 Starting of motor-operated appliances
10 Power input and current
11 Heating
13 Leakage current and electric strength at operating
   temperature
14 Transient overvoltages
15 Moisture resistance
16 Leakage current and electric strength
17 Overload protection of transformers and associated
   circuits
18 Endurance
19 Abnormal operation
20 Stability and mechanical hazards
21 Mechanical strength
22 Construction
23 Internal wiring
24 Components
25 Supply connection and external flexible cords
26 Terminals for external conductors
27 Provision for earthing
28 Screws and connections
29 Clearances, creepage distances and solid insulation
30 Resistance to heat and fire
31 Resistance to rusting
32 Radiation, toxicity and similar hazards
Annexes
Annex A (informative) - Routine tests
Annex B (normative) - Appliances powered by rechargeable
                      batteries
Annex C (normative) - Ageing test on motors
Annex D (normative) - Thermal motor protectors
Annex E (normative) - Needle flame test
Annex F (normative) - Capacitors
Annex G (normative) - Safety isolating transformers
Annex H (normative) - Switches
Annex I (normative) - Motors having basic insulation
                      that is inadequate for the rated
                      voltage of the appliance
Annex J (normative) - Coated printed circuit board
Annex K (normative) - Over-voltage categories
Annex L (informative) - Guidance for the measurement of
                        clearances and creepage distances
Annex M (normative) - Pollution degree
Annex N (normative) - Proof tracking test
Annex O (informative) - Selection and sequence of the tests
                        of Clause 30
Annex P (informative) - Guidance for the application of this
                        standard to appliances used in warm damp
                        equable climates
Annex Q (informative) - Sequence of tests for the evaluation of
                        electronic circuits
Annex R (normative) - Software evaluation
Annex ZA (normative) - Special national conditions
Annex ZB (informative) - A-deviations
Annex ZC (normative) - Normative references to international
                       publications with their corresponding
                       European publications
Annex ZD (informative) - IEC and CENELEC code designations
                         for flexible cords
Bibliography