Customer Support: +1 416-401-8730

Login to i2i Subscription Intertek.com
  • There are no items in your cart
Please enter a keyword to search
Advanced search
Home
BSI
BS EN 60728-11:2017

BS EN 60728-11:2017

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Cable networks for television signals, sound signals and interactive services Safety

Available format(s)

Hardcopy , PDF

Superseded date

03-07-2022

Language(s)

English

Published date

07-14-2017

Publisher

British Standards Institution

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Fundamental requirements
5 Protection against environmental influences
6 Equipotential bonding and earthing
7 Mains-supplied equipment
8 Remote power feeding in cable networks
9 Protection against contact and proximity to electric
   power distribution systems
10 System outlets and transfer points
11 Protection against atmospheric overvoltages
   and elimination of potential Differences
12 Mechanical stability
Annex A (informative) - Earth loop impedance
Annex B (informative) - Use of shield wires to protect
        installations with coaxial cables
Annex C (informative) - Differences in some countries
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZB (informative) - A-deviations
Annex ZC (normative) - Special national conditions

Defines the safety requirements applicable to fixed sited systems and equipment.

IEC 60728-11:2016 deals with the safety requirements applicable to fixed sited systems and equipment. As far as applicable, it is also valid for mobile and temporarily installed systems, for example, caravans. This fourth edition cancels and replaces the third edition published in 2010. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
- Correction of minimum cross-section of bonding conductor in Figure 6, Figure 14 and Figure 17.
- Creation of new symbols for \'overvoltage protective device - (OPD)\' and for \'coaxial overvoltage protective device - (COPD)\'.
- Introduction of new OPD symbol to 3.2, Figure 3 and Figure 6.
- Introduction of new COPD symbol to 3.2 and Figure 19.
- In 3.1 replacement of terms CATV, MATV and SMATV by new terms and definitions due to changes in technology and use of cable networks.
- Extension for remote feeding voltage on subscriber feeder.
- Adaption to Edition 2.0 of the IEC 62305 series.
- Deletion of informative Annex C and normative reference to the simplified software for the calculation of risk due to lightning (Annex J of IEC 62305-2:2006.)
- New subclause 10.2.6 Fully-isolated system outlet provided by means of a FTTH system. The contents of the corrigendum of July 2016 have been included in this copy.

Committee
EPL/100/4
DevelopmentNote
Supersedes BS EN 50083-1 & 03/306253 DC (03/2006) Supersedes 08/30191345 DC. (12/2010)
DocumentType
Standard
Pages
188
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
NBN EN 60728-11 : 2010 Identical
I.S. EN 60728-11:2017 Identical
UNE-EN 60728-11:2012 Identical
EN 60728-11:2017 Identical
DIN EN 60728-11 : 2017 Identical
IEC 60728-11:2016 Identical
NF EN 60728-11 : 2005 Identical

IEC 60950-1:2005+AMD1:2009+AMD2:2013 CSV Information technology equipment - Safety - Part 1: General requirements
EN 50164-2:2008 Lightning Protection Components (LPC) - Part 2: Requirements for conductors and earth electrodes
IEC 60364-5-54:2011 Low-voltage electrical installations - Part 5-54: Selection and erection of electrical equipment - Earthing arrangements and protective conductors
IEC 60825-2:2004+AMD1:2006+AMD2:2010 CSV Safety of laser products - Part 2: Safety of optical fibre communication systems (OFCS)
EN 60825-1:2014/AC:2017-06 SAFETY OF LASER PRODUCTS - PART 1: EQUIPMENT CLASSIFICATION AND REQUIREMENTS (IEC 60825-1:2014)
EN 62305-4:2011/AC:2016 PROTECTION AGAINST LIGHTNING - PART 4: ELECTRICAL AND ELECTRONIC SYSTEMS WITHIN STRUCTURES (IEC 62305-4:2010)
IEC 60050-195:1998 International Electrotechnical Vocabulary (IEV) - Part 195: Earthing and protection against electric shock
IEC GUIDE 112:2017 Guide on the safety of multimedia equipment
R064-004 : 1999 ELECTRICAL INSTALLATIONS OF BUILDINGS - PROTECTION AGAINST ELECTROMAGNETIC INTERFERENCES (EMI) IN INSTALLATIONS OF BUILDINGS
EN 60950-1:2006/A2:2013 INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS (IEC 60950-1:2005/A2:2013, MODIFIED)
HD 60364-5-54:2011/A11:2017 LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 5-54: SELECTION AND ERECTION OF ELECTRICAL EQUIPMENT - EARTHING ARRANGEMENTS AND PROTECTIVE CONDUCTORS
IEC 60825-1:2014 Safety of laser products - Part 1: Equipment classification and requirements
EN 50083-2:2012/A1:2015 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 2: ELECTROMAGNETIC COMPATIBILITY FOR EQUIPMENT
IEC 60728-2:2010 Cable networks for television signals, sound signals and interactive services - Part 2: Electromagnetic compatibility for equipment
IEC 60364-1:2005 Low-voltage electrical installations - Part 1: Fundamental principles, assessment of general characteristics, definitions
EN 50174-3:2013/A1:2017 INFORMATION TECHNOLOGY - CABLING INSTALLATION - PART 3: INSTALLATION PLANNING AND PRACTICES OUTSIDE BUILDINGS
HD 60364-4-442:2012 Low-voltage electrical installations - Part 4-442: Protection for safety - Protection of low-voltage installations against temporary overvoltages due to earth faults in the high-voltage system and due to faults in the low voltage system
EN 62305-3:2011 Protection against lightning - Part 3: Physical damage to structures and life hazard
EN 50174-2 : 2009 AMD 2 2014 INFORMATION TECHNOLOGY - CABLING INSTALLATION - PART 2: INSTALLATION PLANNING AND PRACTICES INSIDE BUILDINGS
HD 60364-1:2008/A11:2017 LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 1: FUNDAMENTAL PRINCIPLES, ASSESSMENT OF GENERAL CHARACTERISTICS, DEFINITIONS
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV Degrees of protection provided by enclosures (IP Code)
IEC 60364-4-44:2007+AMD1:2015 CSV Low-voltage electrical installations - Part 4-44: Protection for safety - Protection against voltage disturbances and electromagnetic disturbances
EN 62305-2:2012 Protection against lightning - Part 2: Risk management
ISO 3864-1:2011 Graphical symbols Safety colours and safety signs Part 1: Design principles for safety signs and safety markings
EN 50164-1:2008 Lightning Protection Components (LPC) - Part 1: Requirements for connection components
IEC 60050-826:2004 International Electrotechnical Vocabulary (IEV) - Part 826: Electrical installations
IEC 62305-4:2010 Protection against lightning - Part 4: Electrical and electronic systems within structures
EN 61140:2016 Protection against electric shock - Common aspects for installation and equipment
IEC 62305-2:2010 Protection against lightning - Part 2: Risk management
EN 60529:1991/AC:2016-12 DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015)
IEC 61140:2016 Protection against electric shock - Common aspects for installation and equipment
EN 60825-2:2004/A2:2010 SAFETY OF LASER PRODUCTS - PART 2: SAFETY OF OPTICAL FIBRE COMMUNICATION SYSTEMS (OFCS)
IEC 60050-851:2008 International Electrotechnical Vocabulary (IEV) - Part 851: Electric welding
EN 50310:2016 Telecommunications bonding networks for buildings and other structures
IEC 60728-1:2014 Cable networks for television signals, sound signals and interactive services - Part 1: System performance of forward paths
IEC 62305-3:2010 Protection against lightning - Part 3: Physical damage to structures and life hazard
IEC 60990:2016 Methods of measurement of touch current and protective conductor current
IEC 60364-5-52:2009 Low-voltage electrical installations - Part 5-52: Selection and erection of electrical equipment - Wiring systems
EN 60990:2016 Methods of measurement of touch current and protective conductor current

View more information
US$335.40
Excluding Tax where applicable
USD
CAD
CHF
CNY
DKK
EUR
GBP
HKD
IDR
INR
JPY
KRW
MXN
NOK
NZD
SEK
SGD
USD
ZAR
Hardcopy - English
PDF - English
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

or

Get in touch with us