BS EN 608:1995
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
03-31-2004
English
04-15-1995
Committees responsible
National foreword
Foreword
0. Introduction
1. Scope
2. Normative references
3. Definitions
4. Safety requirements
4.1 Handles
4.2 Hand protection
4.3 Balance
4.4 Protection against injury by kickback
4.5 Chain catcher
4.6 Spiked bumper
4.7 Chip discharge
4.8 Guide bar cover
4.9 Noise emission
4.10 Vibration
4.11 Throttle trigger
4.12 Ignition switch
4.13 Protection against contact with parts at high voltage
4.14 Clutch
4.15 Carburettor adjustment
4.16 Protection against contact with hot parts
4.17 Exhaust gases
4.18 Chain lubrication
4.19 Tank openings
4.20 Chain tensioning
5. Verification of safety requirements
6. Information for use
6.1 General
6.2 Technical data
6.3 Instruction handbook
6.4 Marking
Annex A (normative) List of hazards
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.