• There are no items in your cart

BS EN 60904-10:2010

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Photovoltaic devices Methods of linearity measurement
Available format(s)

Hardcopy , PDF

Superseded date

11-11-2020

Language(s)

English

Published date

04-30-2010

1 Scope and object
2 Normative references
3 Apparatus
4 Sample selection
5 Procedure for current and voltage linearity test
6 Procedure for short-circuit current linearity from
  two-lamp method
7 Linearity calculation
8 Report
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Specifies procedures used to determine the degree of linearity of any photovoltaic device parameter with respect to a test parameter.

This part of IEC 60904 describes procedures used to determine the degree of linearity of any photovoltaic device parameter with respect to a test parameter. It is primarily intended for use by calibration laboratories, module manufacturers and system designers.

Photovoltaic (PV) module and system performance evaluations, and performance translations from one set of temperature and irradiance conditions to another frequently rely on the use of linear equations (see IEC 60891 and IEC 61829). This standard lays down the linearity requirements and test methods to ensure that these linear equations will give satisfactory results. Indirectly, these requirements dictate the range of the temperature and irradiance variables over which the equations can be used.

The methods of measurement described in this standard apply to all PV devices and are intended to be carried out on a sample or on a comparable device of identical technology. They should be performed prior to all measurement and correction procedures that require a linear device. The methodology used in this standard is similar to that specified in IEC 60891 in which a linear (straight-line) function is fitted to a set of data points using a least-squares fit calculation routine. The variation of the data from this function is also calculated, and the definition of linearity is expressed as an allowable variation percentage.

A device is considered linear when it meets the requirements of 7.3.

General procedures for determining the degree of linearity for these and any other performance parameter are described in Clauses 5 and 6.

Committee
GEL/82
DevelopmentNote
Supersedes 08/30188848 DC. (04/2010)
DocumentType
Standard
Pages
18
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
SN EN 60904-10 : 1998 Identical
IEC 60904-10:2009 Identical
NBN EN 60904-10 : 2010 Identical
DIN EN 60904-10 : 2010 Identical
EN 60904-10:2010 Identical
UNE-EN 60904-10:2011 Identical
NF EN 60904-10 : 2010 Identical
I.S. EN 60904-10:2010 Identical

ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
EN 60904-3:2016 Photovoltaic devices - Part 3: Measurement principles for terrestrial photovoltaic (PV) solar devices with reference spectral irradiance data
IEC 60904-1:2006 Photovoltaic devices - Part 1: Measurement of photovoltaic current-voltage characteristics
EN 60904-9 : 2007 PHOTOVOLTAIC DEVICES - PART 9: SOLAR SIMULATOR PERFORMANCE REQUIREMENTS
IEC 61215:2005 Crystalline silicon terrestrial photovoltaic (PV) modules - Design qualification and type approval
IEC 60904-9:2007 Photovoltaic devices - Part 9: Solar simulator performance requirements
EN 61646:2008 THIN-FILM TERRESTRIAL PHOTOVOLTAIC (PV) MODULES - DESIGN QUALIFICATION AND TYPE APPROVAL
IEC 60904-3 : 3.0 PHOTOVOLTAIC DEVICES - PART 3: MEASUREMENT PRINCIPLES FOR TERRESTRIAL PHOTOVOLTAIC (PV) SOLAR DEVICES WITH REFERENCE SPECTRAL IRRADIANCE DATA
EN 60904-8:2014 Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device
IEC 60904-8:2014 Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device
EN 60904-1:2006 PHOTOVOLTAIC DEVICES - PART 1: MEASUREMENT OF PHOTOVOLTAIC CURRENT-VOLTAGE CHARACTERISTICS
EN 61829:2016 Photovoltaic (PV) array - On-site measurement of current-voltage characteristics
IEC 61646:2008 Thin-film terrestrial photovoltaic (PV) modules - Design qualification and type approval
IEC 61829:2015 Photovoltaic (PV) array - On-site measurement of current-voltage characteristics
EN 60904-7:2009 Photovoltaic devices - Part 7: Computation of the spectral mismatch correction for measurements of photovoltaic devices
IEC 60904-7:2008 Photovoltaic devices - Part 7: Computation of the spectral mismatch correction for measurements of photovoltaic devices
IEC 60904-3:2016 Photovoltaic devices - Part 3: Measurement principles for terrestrial photovoltaic (PV) solar devices with reference spectral irradiance data
EN 60891:2010 Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics
IEC 60891:2009 Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics
EN 61215:2005 Crystalline silicon terrestrial photovoltaic (PV) modules - Design qualification and type approval

View more information
US$170.10
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.