• There are no items in your cart

BS EN ISO 25137-1:2017

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Plastics. Sulfone polymer moulding and extrusion materials Designation system and basis for specifications
Available format(s)

Hardcopy , PDF

Superseded date

06-03-2020

Language(s)

English

Published date

03-31-2017

Foreword
1 Scope
2 Normative references
3 Designation system
4 Examples of designations
Bibliography

Defines a system of designation for sulfone polymer moulding and extrusion materials, including polysulfone (PSU), polyethersulfone (PESU) and polyphenylsulfone (PPSU), which may be used as the basis for specifications.

1.1 This part of ISO 25137 establishes a system of designation for sulfone polymer moulding and extrusion materials, including polysulfone (PSU), polyethersulfone (PESU) and polyphenylsulfone (PPSU), which may be used as the basis for specifications. 1.2 The types of sulfone polymer materials are differentiated from each other by a classification system based on appropriate levels of the designatory properties temperature of deflection under load, melt mass-flow rate, Charpy notched impact strength, tensile modulus and yield stress, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. 1.3 This part of ISO 25137 is applicable to all sulfone polymers that contain ether oxygen, which is a necessary component of the polymers as in the diphenyl sulfone moiety. It applies to sulfone polymer materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colorants, additives, fillers, etc. 1.4 It is not intended to imply that materials having the same designation necessarily give the same performance. This part of ISO 25137 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they shall be determined in accordance with the test methods specified in Part 2 of this International Standard, if suitable. 1.5 In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).

Committee
PRI/21
DevelopmentNote
Renumbers and supersedes BS ISO 25137-1. 2017 Version incorporates corrigendum to BS ISO 25137-1. Supersedes 07/30152072 DC. (03/2017)
DocumentType
Standard
Pages
20
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
EN ISO 25137-1:2017 Identical
ISO 25137-1:2009 Identical

ASTM D 6394 : 2014 : REDLINE Standard Specification for Sulfone Plastics (SP)
ISO 25137-2:2009 Plastics Sulfone polymer moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties
ISO 1043-1:2011 Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics

View more information
US$160.51
Excluding Tax where applicable

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.