BS ISO 15118-3 : 2015

Superseded

View Superseded by

ROAD VEHICLES - VEHICLE TO GRID COMMUNICATION INTERFACE - PART 3: PHYSICAL AND DATA LINK LAYER REQUIREMENTS

Available format(s)

Hardcopy , PDF

Superseded date

05-31-2016

Language(s)

English

Published date

01-01-2015

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conventions
6 System architecture
7 Connection coordination
8 Timings and constants
9 Matching EV - EVSE process
10 EMC requirements
11 Signal coupling
12 Layer 2 interfaces
Annex A (normative) - HomePlug Green PHY on control
pilot line
Annex B (informative) - IEEE 1901.2 G3-PLC profile on
control pilot line
Bibliography

Describes the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1].

Committee	AUE/16
DevelopmentNote	Supersedes 12/30246906 DC. (06/2015) Renumbered and superseded by BS EN ISO 15118-3. (05/2016)
DocumentType	Standard
Pages	90
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS EN ISO 15118-3:2016
Supersedes	12/30246906 DC : 0

IEC 62196-2:2016	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
IEC TS 62763:2013	Pilot function through a control pilot circuit using PWM (pulse width modulation) and a control pilot wire
IEC 62196-3:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers
ISO 15118-1:2013	Road vehicles Vehicle to grid communication interface Part 1: General information and use-case definition
ISO 15118-2:2014	Road vehicles Vehicle-to-Grid Communication Interface Part 2: Network and application protocol requirements
IEC 61851-1:2017	Electric vehicle conductive charging system - Part 1: General requirements
IEC 62196-1:2014	Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements