CEN/TS 15442:2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Principle
6 Development of a sampling plan
  6.1 Principle
  6.2 Definition of overall objectives
  6.3 Definition of a lot and determining lot size
  6.4 Determination of the sampling procedure
  6.5 Determination of the number of increments
  6.6 Determination of minimum sample size
  6.7 Determination of the minimum increment size
  6.8 Determination of the effective increment and sample sizes
  6.9 Selection of distribution of increments over a lot
7 Implementation of a sampling plan
  7.1 Sampling from a material flow
  7.2 Sampling from a vehicle
  7.3 Sampling from a static lot
8 Handling and storage of samples
9 Precision
Annex A (normative) - Step-by-step plan for the development of a
        sampling plan
Annex B (informative) - Guideline for a sampling plan
Annex C (normative) - Sampling equipment and implements
Annex D (normative) - Determination of minimum sample size
Annex E (normative) - Determination of minimum increment size for
        sampling from material flows
Annex F (normative) - Determination of minimum increment size for
        sampling from static lots or vehicles
Annex G (normative) - Implementation of sampling from a material
        flow
Annex H (normative) - Implementation of sampling from a static
        lot or vehicle
Annex I (normative) - Minimum sample size required for analysis
Bibliography