CSA C391 : 2015

Superseded

View Superseded by

TESTING OF THREE-PHASE SYNCHRONOUS MACHINES DURING REFURBISHMENT

Available format(s)

Hardcopy , PDF

Superseded date

03-06-2020

Language(s)

English, French

Published date

01-01-2015

Publisher

Canadian Standards Association

Preface
0 Introduction
1 Scope
2 Reference publications
3 Definitions
4 Safety for inspections and tests
5 Test conditions, equipment, and instrumentation
6 Summary of inspection and test
7 Incoming inspection
8 DC resistance test of stator winding
9 Stator core magnetic circuit (laminations) testing
10 Salient pole piece testing
11 No-load testing and inspection
12 Supplementary tests
Annex A (informative) - Special tables, charts and reports
Annex B (informative) - Additional factors that help maintain
        or enhance efficiency
Annex C (informative) - Synchronous motor fundamentals
Annex D (informative) - Other large motor technologies
Annex E (informative) - Synchronous generators
Annex F (informative) - MLT Definition
Annex G (informative) - Synchronous machine exciter systems
        and amortisseur windings
Annex H (informative) - V curves for typical synchronous
        motors with a variable excitation
Annex I (informative) - Bibliography

Includes three-phase, alternating current, salient pole synchronous machines 150 kW and up, 200 through 13,800 volts, 60 and 50 Hertz and will assist in verifying the machine efficiency has been maintained.

DevelopmentNote	French Edition issued on 01-06-2015. (07/2015)
DocumentType	Standard
Pages	54
PublisherName	Canadian Standards Association
Status	Superseded
SupersededBy	CSA C391:15 (R2020)

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
NEMA MG 1 : 2016	MOTORS AND GENERATORS
ANSI/NCSL Z540 1 : 94(R2002)	CALIBRATION - CALIBRATION LABORATORIES AND MEASURING AND TEST EQUIPMENT - GENERAL REQUIREMENTS
IEC 60034-2-1:2014	Rotating electrical machines - Part 2-1: Standard methods for determining losses and efficiency from tests (excluding machines for traction vehicles)
IEEE 115-2009 REDLINE	IEEE Guide for Test Procedures for Synchronous Machines Part I—Acceptance and Performance Testing Part II—Test Procedures and Parameter Determination for Dynamic Analysis
CSA C22.2 No. 100 : 2014	MOTORS AND GENERATORS
IEEE 1068-2015 REDLINE	IEEE Standard for the Repair and Rewinding of AC Electric Motors in the Petroleum, Chemical, and Process Industries
IEEE 43-2013 REDLINE	IEEE Recommended Practice for Testing Insulation Resistance of Electric Machinery
ISO 10012-1:1992	Quality assurance requirements for measuring equipment Part 1: Metrological confirmation system for measuring equipment