CSA E1008.1 : 0

Withdrawn

RESIDUAL CURRENT OPERATED CIRCUIT-BREAKERS WITHOUT INTEGRAL OVERCURRENT PROTECTION FOR HOUSEHOLD AND SIMILAR USES (RCCBS) - PART 1: GENERAL RULES

Available format(s)

Hardcopy , PDF

Withdrawn date

08-01-2007

Language(s)

English

Publisher

Canadian Standards Association

FOREWORD
INTRODUCTION
Clause
PART 1: GENERAL RULES
1 Scope
2 Normative references
3 Definitions
4 Classification
5 Characteristics of RCCB's
6 Marking and other product information
7 Standard conditions for operation in service and for
installation
8 Requirements for construction and operation
9 Tests
Figures and Tables
ANNEXES (normatives)
A - Test sequence and number of samples to be submitted
for certification purposes
B - Determination of clearances and creepage distances
C - Arrangement for short-circuit tests
D - Routine tests
ANNEXES (informatives)
IA - Methods of determination of short-circuit power-factor
IB - Glossary of symbols
IC - Examples of terminal designs
ID - Correspondence between ISO and AWG copper conductors

Requirements, definitions and tests covering all types of residual current operated circuit-breakers (RCCBs) are covered either by functionally dependent or independent on line voltage normally for household use. These RCCBs are intended for protection against shock hazard and do not incorporate overcurrent protection.

DocumentType	Standard
Pages	250
PublisherName	Canadian Standards Association
Status	Withdrawn

IEC 60038:2009	IEC standard voltages
IEC 60695-2-1:1991	Fire hazard testing - Part 2: Test methods - Section 1: Glow-wire test and guidance
C22.1-15	Canadian Electrical Code, Part I (23rd Edition), Safety Standard for Electrical Installations
IEC 60050-151:2001	International Electrotechnical Vocabulary (IEV) - Part 151: Electrical and magnetic devices
IEC 60884-1:2002+AMD1:2006+AMD2:2013 CSV	Plugs and socket-outlets for household and similar purposes - Part1: General requirements
IEC 60050-441:1984	International Electrotechnical Vocabulary (IEV) - Part 441: Switchgear, controlgear and fuses
CSA C22.2 No. 21 : 2014	CORD SETS AND POWER-SUPPLY CORDS
IEC 60364-5-53:2001+AMD1:2002+AMD2:2015 CSV	Electrical installations of buildings - Part 5-53: Selection and erection of electrical equipment - Isolation, switching and control
CSA C22.2 No. 144 : 1991	GROUND FAULT CIRCUIT INTERRUPTERS
IEC 60529:1989+AMD1:1999+AMD2:2013 CSV	Degrees of protection provided by enclosures (IP Code)
IEC 60755:2017	General safety requirements for residual current operated protective devices
IEC 60364-4-443:1995+AMD1:1998 CSV	Electrical installations of buildings - Part 4: Protection for safety - Chapter 44: Protection against overvoltages - Section 443: Protection against overvoltages of atmospheric origin or due to switching
IEC 60068-2-28:1990	Environmental testing - Part 2: Tests. Guidance for damp heat tests
IEC 60068-2-30:2005	Environmental testing - Part 2-30: Tests - Test Db: Damp heat, cyclic (12 h + 12 h cycle)