CSA S136.1 : 2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
06-01-2013
01-12-2013
1 Scope and Application
2 Definitions, Symbols, Units and Reference Publications
2.1 Definitions
2.2 Symbols
2.3 Units
2.4 Reference Publications
3 Materials
3.2 Strength Levels Used for Design
3.3 Ductility Requirements
3.4 Thickness Tolerances
4 Safety Criterion and Loads
5 General Design Considerations
5.2 Cold Work of Forming
5.3 Maximum Effective Slenderness Ratio for Members in
Compression
5.4 Maximum Flat Width Ratios for Elements in Compression
5.5 Maximum Section Depths
6 Member Resistance
6.1 General
6.2 Resistance Factors for Strength Analysis
6.3 Members in Tension
6.4 Members in Bending
6.5 Transverse Stiffeners for Beam Webs
6.6 Members in Compression (Concentrically Loaded)
6.7 Combined Axial Load and Bending
6.8 Wall Studs
7 Connections
7.1 General
7.2 Welded Connections
7.3 Mechanical Fasteners (Bolts, Rivets, and Screws)
7.4 Connections in Built-Up Members
7.5 Spacing of Fasteners in Compressive Elements
8 Bracing
8.1 General
8.2 Sections that are Symmetric Relative to the Plane
of Loading
8.3 Channels and Z-Sections in Bending
9 Testing
9.1 General
9.2 Types of Tests
9.3 Test Procedures
10 Fabrication
11 Erection
12 Protection
Figures
Tables
Appendix A - References
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.