• There are no items in your cart

EN 12897:2016

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Water supply - Specification for indirectly heated unvented (closed) storage water heaters
Superseded date

02-12-2020

Published date

06-15-2016

European foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Requirements
5 Marking
6 Evaluation of conformity
7 Technical documents
Annex A (normative) - Hot water safety and performance
        testing
Annex B (normative) - Measurement of standing heat loss
        for factory insulated storage water heaters
Annex C (informative) - Inspection access
Annex ZA (informative) - Relationship between this
         European Standard and the requirements of Commission
         Delegated Regulation (EU) No 812/2013 of February 2013
         supplementing Directive 2010/30/EU regarding energy
         labelling for water heaters and hot water storage tanks
Annex ZB (informative) - Relationship between this European
         Standard and the requirements of Commission Regulation
         (EU) No 814/2013 of 2 August 2013 implementing Directive
         2009/125/EC with regard to Ecodesign requirements for
         water heaters and hot water storage tanks
Bibliography

This European Standard specifies the constructional and performance requirements and methods of test for indirectly heated, unvented (closed) storage water heaters of up to 2 000 l volume suitable for connection to a water supply at a pressure between 0,05 MPa and 1,0 MPa (0,5 bar and 10 bar), and fitted with control and safety devices designed to prevent the temperature of the stored drinking water from reaching 95 °C.Whilst storage water heaters intended primarily for direct heating are not covered by this standard, it does allow the provision of electric heating elements for auxiliary use.

Committee
CEN/TC 164
DevelopmentNote
Supersedes PREN 12897. (06/2016)
DocumentType
Standard
PublisherName
Comite Europeen de Normalisation
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
DIN EN 12897:2016-12 Identical
NBN EN 12897 : 2016 Identical
DIN EN 12897:2006-09 Identical
BS EN 12897:2016 Identical
UNE-EN 12897:2017 Identical
I.S. EN 12897:2016 Identical
PN EN 12897 : 2016 Identical
NEN EN 12897 : 2016 Identical
SN EN 12897 : 2016 Identical
NF EN 12897 : 2016 Identical
NS EN 12897 : 2006 Identical
UNI EN 12897 : 2007 Identical
ONORM EN 12897 : 2016 Identical

UNI EN 12977-4 : 2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
UNI CEN/TS 12977-4 : 2010 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
NF EN 806-5 : 2012 SPECIFICATION FOR INSTALLATIONS INSIDE BUILDINGS CONVEYING WATER FOR HUMAN CONSUMPTION - PART 5: OPERATION AND MAINTENANCE
I.S. EN 15332:2007 HEATING BOILERS - ENERGY ASSESSMENT OF HOT WATER STORAGE SYSTEMS
CEN/TS 12977-4:2010 Thermal solar systems and components - Custom built systems - Part 4: Performance test methods for solar combistores
EN 12831-3:2017 Energy performance of buildings - Method for calculation of the design heat load - Part 3: Domestic hot water systems heat load and characterisation of needs, Module M8-2, M8-3
DIN EN 12976-1:2017-04 Thermal solar systems and components - Factory made systems - Part 1: General requirements
11/30247846 DC : 0 BS EN 12977-4 - THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
PREN 15332 : DRAFT 2017 HEATING BOILERS - ENERGY ASSESSMENT OF HOT WATER STORAGE SYSTEMS
I.S. EN 12977-4:2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
DIN EN 15316-3-3:2008-06 HEATING SYSTEMS IN BUILDINGS - METHOD FOR CALCULATION OF SYSTEM ENERGY REQUIREMENTS AND SYSTEM EFFICIENCIES - PART 3-3: DOMESTIC HOT WATER SYSTEMS, GENERATION
BS EN 15316-3-3:2007 Heating systems in buildings. Method for calculation of system energy requirements and system efficiencies Domestic hot water systems, generation
I.S. EN 12977-2:2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 2: TEST METHODS FOR SOLAR WATER HEATERS AND COMBISYSTEMS
DIN EN 12977-3:2016-08 (Draft) THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 3: PERFORMANCE TEST METHODS FOR SOLAR WATER HEATER STORES
BS EN 12977-4:2012 Thermal solar systems and components. Custom built systems Performance test methods for solar combistores
DIN EN 15332:2008-01 HEATING BOILERS - ENERGY ASSESSMENT OF HOT WATER STORAGE SYSTEMS
I.S. EN 12976-1:2017 THERMAL SOLAR SYSTEMS AND COMPONENTS - FACTORY MADE SYSTEMS - PART 1: GENERAL REQUIREMENTS
VDI 3805 Blatt 20:2017-02 Product data exchange in the building services - Storage tanks and instantaneous water heater
DIN EN 12831-3:2017-09 ENERGY PERFORMANCE OF BUILDINGS - METHOD FOR CALCULATION OF THE DESIGN HEAT LOAD - PART 3: DOMESTIC HOT WATER SYSTEMS HEAT LOAD AND CHARACTERISATION OF NEEDS, MODULE M8-2, M8-3
BS EN 12977-3:2012 Thermal solar systems and components. Custom built systems Performance test methods for solar water heater stores
11/30247855 DC : 0 BS EN 12977-3 - THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 3: PERFORMANCE TEST METHODS FOR SOLAR WATER HEATER STORES
I.S. EN 12831-3:2017 ENERGY PERFORMANCE OF BUILDINGS - METHOD FOR CALCULATION OF THE DESIGN HEAT LOAD - PART 3: DOMESTIC HOT WATER SYSTEMS HEAT LOAD AND CHARACTERISATION OF NEEDS, MODULE M8-2, M8-3
EN 12977-2:2018 Thermal solar systems and components - Custom built systems - Part 2: Test methods for solar water heaters and combisystems
EN 12977-1:2018 Thermal solar systems and components - Custom built systems - Part 1: General requirements for solar water heaters and combisystems
UNE-EN 12977-3:2012 Thermal solar systems and components - Custom built systems - Part 3: Performance test methods for solar water heater stores
DIN EN 12976-1:2014-07 (Draft) THERMAL SOLAR SYSTEMS AND COMPONENTS - FACTORY MADE SYSTEMS - PART 1: GENERAL REQUIREMENTS
EN 12976-1:2017 Thermal solar systems and components - Factory made systems - Part 1: General requirements
DIN EN 12831-3 E : 2017 ENERGY PERFORMANCE OF BUILDINGS - METHOD FOR CALCULATION OF THE DESIGN HEAT LOAD - PART 3: DOMESTIC HOT WATER SYSTEMS HEAT LOAD AND CHARACTERISATION OF NEEDS, MODULE M8-2, M8-3
DIN EN 806-5:2012-04 Specifications for installations inside buildings conveying water for human consumption - Part 5: Operation and maintenance
BS EN 806-5:2012 Specifications for installations inside buildings conveying water for human consumption Operation and maintenance
09/30200073 DC : 0 BS EN 806-5 - SPECIFICATION FOR INSTALLATIONS INSIDE BUILDINGS CONVEYING WATER FOR HUMAN CONSUMPTION - PART 5: OPERATION AND MAINTENANCE
DD CEN/TS 12977-4 : DRAFT MAY 2010 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
14/30311710 DC : 0 BS EN 12831-3 - HEATING SYSTEMS AND WATER BASED COOLING SYSTEMS IN BUILDINGS - METHOD FOR CALCULATION OF THE DESIGN HEAT LOAD - PART 3: DOMESTIC HOT WATER SYSTEMS HEAT LOAD AND CHARACTERISATION OF NEEDS
17/30348435 DC : 0 BS EN 15332 - HEATING BOILERS - ENERGY ASSESSMENT OF HOT WATER STORAGE SYSTEMS
I.S. EN 15316-3-3:2007 HEATING SYSTEMS IN BUILDINGS - METHOD FOR CALCULATION OF SYSTEM ENERGY REQUIREMENTS AND SYSTEM EFFICIENCIES - PART 3-3: DOMESTIC HOT WATER SYSTEMS, GENERATION
EN 12977-4:2018 Thermal solar systems and components - Custom built systems - Part 4: Performance test methods for solar combistores
PREN 12977-3 : DRAFT 2011 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 3: PERFORMANCE TEST METHODS FOR SOLAR WATER HEATER STORES
EN 12977-3:2018 Thermal solar systems and components - Custom built systems - Part 3: Performance test methods for solar water heater stores
BS EN 12976-1:2017 Thermal solar systems and components. Factory made systems General requirements
BS EN 15332:2007 Heating boilers. Energy assessment of hot water storage systems
DIN EN 15332 E : 2008 HEATING BOILERS - ENERGY ASSESSMENT OF HOT WATER STORAGE SYSTEMS
EN 15316-3-3:2007 Heating systems in buildings - Method for calculation of system energy requirements and system efficiencies - Part 3-3: Domestic hot water systems, generation
EN 15332:2007 Heating boilers - Energy assessment of hot water storage systems
EN 806-5:2012 Specifications for installations inside buildings conveying water for human consumption - Part 5: Operation and maintenance
BS EN 12977-1:2012 Thermal solar systems and components. Custom built systems General requirements for solar water heaters and combisystems
DIN EN 12977-4:2016-08 (Draft) THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
BS EN 12831-3:2017 Energy performance of buildings. Method for calculation of the design heat load Domestic hot water systems heat load and characterisation of needs, Module M8-2, M8-3
UNI EN 806-5 : 2012 SPECIFICATIONS FOR INSTALLATIONS INSIDE BUILDINGS CONVEYING WATER FOR HUMAN CONSUMPTION - PART 5: OPERATION AND MAINTENANCE
I.S. EN 806-5:2012 SPECIFICATIONS FOR INSTALLATIONS INSIDE BUILDINGS CONVEYING WATER FOR HUMAN CONSUMPTION - PART 5: OPERATION AND MAINTENANCE
I.S. EN 12977-3:2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 3: PERFORMANCE TEST METHODS FOR SOLAR WATER HEATER STORES
I.S. EN 12977-1:2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 1: GENERAL REQUIREMENTS FOR SOLAR WATER HEATERS AND COMBISYSTEMS
S.R. CEN TS 12977-4:2010 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 4: PERFORMANCE TEST METHODS FOR SOLAR COMBISTORES
UNE-EN 806-5:2013 Specifications for installations inside buildings conveying water for human consumption - Part 5: Operation and maintenance
UNE-EN 12977-4:2012 Thermal solar systems and components - Custom built systems - Part 4: Performance test methods for solar combistores
UNI EN 12977-3 : 2012 THERMAL SOLAR SYSTEMS AND COMPONENTS - CUSTOM BUILT SYSTEMS - PART 3: PERFORMANCE TEST METHODS FOR SOLAR WATER HEATER STORES

IEC 60730-2-9:2015 RLV Automatic electrical controls - Part 2-9: Particular requirements for temperature sensing controls
EN 15332:2007 Heating boilers - Energy assessment of hot water storage systems
EN 1490:2000 Building valves - Combined temperature and pressure relief valves - Tests and requirements
EN 60730-2-9:2010 Automatic electrical controls for household and similar use - Part 2-9: Particular requirements for temperature sensing controls
89/106/EEC : 1988 COUNCIL DIRECTIVE OF 21 DECEMBER 1988 ON THE APPROXIMATION OF LAWS, REGULATIONS AND ADMINISTRATIVE PROVISIONS OF THE MEMBER STATES RELATING TO CONSTRUCTION PRODUCTS
EN 1567:1999 Building valves - Water pressure reducing valves and combination water pressure reducing valves - Requirements and tests
EN 1717:2000 Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow
IEC 60379:1987 Methods for measuring the performance of electric storage water-heaters for household purposes
EN 1491:2000 Building valves - Expansion valves - Tests and requirements
EN 1488:2000 Building valves - Expansion groups - Tests and requirements
EN 1487:2014 Building valves - Hydraulic safety groups - Tests and requirements
EN ISO 9001:2015 Quality management systems - Requirements (ISO 9001:2015)
EN 1489:2000 Building valves - Pressure safety valves - Tests and requirements
EN 13959:2004 Anti-pollution check valves - DN 6 to DN 250 inclusive family E, type A, B, C and D
ISO 9001:2015 Quality management systems — Requirements
EN 60379:2004 Methods for measuring the performance of electric storage water-heaters for household purposes
2009/125/EC : 2009 AMD 1 2012 DIRECTIVE 2009/125/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL OF 21 OCTOBER 2009 ESTABLISHING A FRAMEWORK FOR THE SETTING OF ECODESIGN REQUIREMENTS FOR ENERGY-RELATED PRODUCTS (RECAST) (TEXT WITH EEA RELEVANCE)

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.