EN 302 537-1 : 1.1.2

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
   2.1 Normative references
   2.2 Informative references
3 Definitions, symbols and abbreviations
   3.1 Definitions
   3.2 Symbols
   3.3 Abbreviations
4 Technical requirements and specifications
   4.1 General requirements
   4.2 Presentation of equipment for testing purposes
   4.3 Mechanical and electrical design
   4.4 Declarations by the provider
   4.5 Auxiliary test equipment
   4.6 Interpretation of the measurement results
5 Test conditions, power sources and ambient temperatures
   5.1 Normal and extreme test conditions
   5.2 Test power source
   5.3 Normal test conditions
   5.4 Extreme test conditions
6 General conditions
   6.1 Normal test signals and test modulation
   6.2 Antennas
   6.3 Artificial antenna
   6.4 Test fixture for ULP-AMD, ULP-AMD-P and
        ULP-AMI-P devices
   6.5 Test fixture for ULP-AMI and ULP-BWD
   6.6 Test sites and general arrangements for
        radiated measurements
   6.7 Modes of operation of the transmitter
   6.8 Measuring receiver
7 Measurement uncertainty
8 Methods of measurement and limits for transmitter
   parameters
   8.1 Frequency error
   8.2 Emission bandwidth measurement
   8.3 Effective radiated power of the fundamental emission
   8.4 Spurious emissions
   8.5 Frequency stability under low voltage conditions
   8.6 Spectrum access based on low power and low duty cycle
9 Methods of measurement and limits for receiver parameters
   9.1 Spurious radiation
10 Requirements for spectrum access and measuring methods
   for monitoring systems using LBT and AFA
   10.1 Purpose
   10.2 LBT threshold power level
   10.3 Monitoring system bandwidth
   10.4 Monitoring system scan cycle time and minimum channel
        monitoring period
   10.5 Channel access based on ambient levels relative to the
        calculated access LBT threshold level, P[Th]
   10.6 Discontinuation of MEDS session if a silent period
        greater than or equal to 5 s occurs
   10.7 Use of pre-scanned alternate channel
Annex A (normative): Radiated measurements
      A.1 Test sites and general arrangements for measurements
          involving the use of radiated fields
      A.2 Guidance on the use of radiation test sites
      A.3 Further optional alternative indoor test site using
          a fully anechoic chamber
Annex B (normative): Technical performance of the spectrum analyser
Annex C (informative): Bibliography
History