• There are no items in your cart

EN 61967-4 : 2002 COR 2017

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

INTEGRATED CIRCUITS - MEASUREMENT OF ELECTROMAGNETIC EMISSIONS, 150 KHZ TO 1 GHZ - PART 4: MEASUREMENT OF CONDUCTED EMISSIONS - 1 OHM/150 OHM DIRECT COUPLING METHOD (IEC 61967-4:2002/COR1:2017)
Amendment of

EN 61967-4:2002

Superseded date

02-12-2022

Published date

01-12-2013

FOREWORD
1 Scope
2 Normative references
3 Definitions
4 General
  4.1 Measurement basics
  4.2 RF current measurement
  4.3 RF voltage measurement at IC pins
  4.4 Assessment of the measurement technique
5 Test conditions
6 Test equipment
  6.1 Test receiver specification
  6.2 RF current probe specification
  6.3 Test of the RF current probe capability
  6.4 Matching network specification
7 Test set-up
  7.1 General test configuration
  7.2 Printed circuit test board layout
8 Test procedure
9 Test report
Annex A (normative) Probe calibration procedure
Annex B (informative) Classification of conducted
                       emission levels
  B.1 Introductory remark
  B.2 General
  B.3 Definition of emission levels
  B.4 Presentation of results
Annex C (informative) Example of reference levels for
                       automotive applications
  C.1 Introductory remark
  C.2 General
  C.3 Reference levels
Annex D (informative) EMC requirements and how to use
                       EMC IC measurement techniques
  D.1 Introduction
  D.2 Using EMC measurement procedures
  D.3 Assessment of the IC influence to the EMC behaviour
      of the modules
Annex E (informative) Example of a test set-up consisting of
                       an EMC main test board and an EMC
                       IC test board
  E.1 The EMC main test board
  E.2 EMC IC test board
Annex F (informative) 150 ohms direct coupling networks for
        common mode emission measurements of differential
        mode data transfer ICs and similar circuits
Annex ZA (normative) Normative references to international
                       publications with their corresponding
                       European publications

Specifies a method to measure the conducted electromagnetic emission (EME) of integrated circuits by direct radio frequency (RF) current measurement with a 1 ohm resistive probe and RF voltage measurement using a 150 ohm coupling network.

Committee
SR 47A
DocumentType
Standard
PublisherName
European Committee for Standards - Electrical
Status
Superseded
SupersededBy
Supersedes

BS EN 62228-2:2017 Integrated circuits. EMC evaluation of transceivers LIN transceivers
EN 62132-4:2006 Integrated circuits - Measurement of electromagnetic immunity 150 kHz to 1 GHz - Part 4: Direct RF power injection method
CEI EN 62228-2 : 1ED 2017 INTEGRATED CIRCUITS - EMC EVALUATION OF TRANSCEIVERS - PART 2: LIN TRANSCEIVERS
BS EN 61967-6 : 2002 INTEGRATED CIRCUITS - MEASUREMENT OF ELECTROMAGNETIC EMISSIONS, 150 KHZ TO 1 GHZ - PART 6: MEASUREMENT OF CONDUCTED EMISSIONS - MAGNETIC PROBE METHOD
I.S. EN 62228-2:2017 INTEGRATED CIRCUITS - EMC EVALUATION OF TRANSCEIVERS - PART 2: LIN TRANSCEIVERS
EN IEC 62969-1:2018 Semiconductor devices - Semiconductor interface for automotive vehicles - Part 1: General requirements of power interface for automotive vehicle sensors
CEI EN 62132-4 : 2006 CIRCUITS INTEGRES - MESURE DE L'IMMUNITE ELECTROMAGNETIQUE 150 KHZ A 1 GHZ - PARTIE 4: METHODE D'INJECTION DIRECTE DE PUISSANCE RF
BS EN 62132-4:2006 Integrated circuits. Measurement of electromagnetic immunity. 150 kHz to 1 GHz Direct RF power injection method
EN 61967-6:2002/A1:2008 INTEGRATED CIRCUITS - MEASUREMENT OF ELECTROMAGNETIC EMISSIONS, 150 KHZ TO 1 GHZ - PART 6: MEASUREMENT OF CONDUCTED EMISSIONS - MAGNETIC PROBE METHOD
I.S. EN 61967-6:2003 INTEGRATED CIRCUITS - MEASUREMENT OF ELECTROMAGNETIC EMISSIONS, 150 KHZ TO 1 GHZ - PART 6: MEASUREMENT OF CONDUCTED EMISSIONS - MAGNETIC PROBE METHOD
I.S. EN 62132-4:2006 INTEGRATED CIRCUITS - MEASUREMENT OF ELECTROMAGNETIC IMMUNITY 150 KHZ TO 1 GHZ - PART 4: DIRECT RF POWER INJECTION METHOD
EN 62228-2:2017 Integrated circuits - EMC evaluation of transceivers - Part 2: LIN transceivers

EN 55016-1-4:2010/A2:2017 SPECIFICATION FOR RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS AND METHODS - PART 1-4: RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS - ANTENNAS AND TEST SITES FOR RADIATED DISTURBANCE MEASUREMENTS (CISPR 16-1-4:2010/A2:2017)
IEC 61967-1:2002 Integrated circuits - Measurement of electromagnetic emissions, 150 kHz to 1 GHz - Part 1: General conditions and definitions
CISPR 16-1-4:2010+AMD1:2012+AMD2:2017 CSV Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Antennas and test sites for radiated disturbance measurements
CISPR 16-1-1:2015 Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-1: Radio disturbance and immunity measuring apparatus - Measuring apparatus
CISPR 16-1-3:2004+AMD1:2016 CSV Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-3: Radio disturbance and immunity measuring apparatus - Ancillary equipment - Disturbance power
CISPR 16-1-5:2014+AMD1:2016 CSV Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-5: Radio disturbance and immunity measuring apparatus - Antenna calibration sites and reference test sites for 5 MHz to 18 GHz
EN 61967-1:2002 Integrated circuits - Measurement of electromagnetic emissions, 150 kHz to 1 GHz - Part 1: General conditions and definitions
IEC 61000-4-6 : 4.0 ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4-6: TESTING AND MEASUREMENT TECHNIQUES - IMMUNITY TO CONDUCTED DISTURBANCES, INDUCED BY RADIO-FREQUENCY FIELDS
IEC 61000-4-6:2013 Electromagnetic compatibility (EMC) - Part 4-6: Testing and measurement techniques - Immunity to conducted disturbances, induced by radio-frequency fields
EN 55016-1-5:2015/A1:2017 SPECIFICATION FOR RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS AND METHODS - PART 1-5: RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS - ANTENNA CALIBRATION SITES AND REFERENCE TEST SITES FOR 5 MHZ TO 18 GHZ (CISPR 16-1-5:2014/A1:2016)
EN 55016-1-3:2006/A1:2016 SPECIFICATION FOR RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS AND METHODS - PART 1-3: RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS - ANCILLARY EQUIPMENT - DISTURBANCE POWER (CISPR 16-1-3:2004)
EN 61000-4-6:2014/AC:2015 ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4-6: TESTING AND MEASUREMENT TECHNIQUES - IMMUNITY TO CONDUCTED DISTURBANCES, INDUCED BY RADIO-FREQUENCY FIELDS (IEC 61000-4-6:2013)
EN 55016-1-1:2010/A2:2014 SPECIFICATION FOR RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS AND METHODS - PART 1-1: RADIO DISTURBANCE AND IMMUNITY MEASURING APPARATUS - MEASURING APPARATUS (CISPR 16-1-1:2010/A2:2014)

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.