Name: EN ISO 19065-1:2014
Brand: CEN

Plastics - Acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials - Part 1: Designation system and basis for specifications (ISO 19065-1:2014)

Published date

12-03-2014

Publisher

Comite Europeen de Normalisation

Foreword
Introduction
1 Scope
2 Normative references
3 Designation system
4 Example of a designation

ISO 19065-1:2014 establishes a system of designation for acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials, which may be used as the basis for specifications.The types of ASA, AEPDS and ACS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties: a) Vicat softening temperature, b) melt volume-flow rate, c) Charpy notched impact strength, d) tensile modulus, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.

Committee	CEN/TC 249
DevelopmentNote	Supersedes EN ISO 6402-1. (12/2014)
DocumentType	Standard
PublisherName	Comite Europeen de Normalisation
Status	Current
Supersedes	EN ISO 6402-1 : 2002

Standards	Relationship
NBN EN ISO 19065-1 : 2015	Identical
UNI EN ISO 19065-1 : 2015	Identical
NEN EN ISO 19065-1 : 2014	Identical
UNE-EN ISO 19065-1:2015	Identical
I.S. EN ISO 19065-1:2014	Identical
BS EN ISO 19065-1:2014	Identical
NS EN ISO 19065-1 : 2014	Identical
SN EN ISO 19065-1:2015	Identical
NF EN ISO 19065-1 : 2015	Identical
ISO 19065-1:2014	Identical
PN EN ISO 19065-1 : 2015	Identical
DIN EN ISO 19065-1:2015-03	Identical
DIN EN ISO 19065-1 E : 2015	Identical

ISO 1043-2:2011	Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials
ISO 1043-1:2011	Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics
ISO 6402-2:2003	Plastics Acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties