I.S. EN 61192-2:2003
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Hardcopy , PDF
05-29-2019
English
04-25-2003
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
4.1 Classification
4.2 Conflict
4.3 Interpretation of requirements
4.4 Antistatic precautions
5 Component preparation processes
6 Solder paste deposition process qualification
6.1 Solder paste characteristics
6.2 Assessment of the process
6.3 Solder paste deposition - Screen and stencil printing
methods - Process control limits
7 Non-conductive adhesive deposition process
7.1 Pot life
7.2 Inter-stage storage and handling
7.3 Adhesive tackiness
7.4 Assessment of the adhesive attachment process
7.5 Adhesive deposition - Syringe dispensing method - Small
components - Process control limits
8 Temporary masking processes
9 Component placement processes
9.1 Assessment of the process
9.2 Discrete components with gull-wing leads
9.3 IC components with flat-ribbon, L- or gull-wing leads on
two sides
9.4 IC components with flat-ribbon, L- or gull-wing leads on
four sides, for example, quad flat packs
9.5 Components with round or flattened (coined) leads
9.6 IC component packages with J-leads on two and four sides,
for example, SOJ, PLCC
9.7 Leadless rectangular components with metallized
terminations
9.8 Components with cylindrical endcap terminations
9.9 Bottom-only terminations on leadless components
9.10 Leadless chip carriers with castellated terminations
9.11 Components with butt leads
9.12 Components with inward L-shaped ribbon leads
9.13 Flat-lug leads on power dissipating components
10 Post-placement rework
10.1 Rework of components placed on solder paste
10.2 Rework of components placed on non-conductive adhesive
11 Adhesive curing
12 Soldering processes
13 Cleaning processes
14 Hand placement and hand soldering, including hand
rework/repair
15 Electrical test
Annex A (normative)
A.1 Introduction
A.2 Example solder fillets and alignment: flat-ribbon, L- and
gull-wing leads
A.3 Example solder fillets and alignment: round or flattened
(coined) leads
A.4 Example solder fillets and alignment: J-leads
A.5 Example solder fillets and alignment: rectangular or
square end leadless components
A.6 Example solder fillets and alignment: cylindrical end cap
terminations, for example, MELFs
A.7 Example solder fillets and alignment: bottom-only
terminations on leadless components
A.8 Example solder fillets and alignment: leadless chip
carriers with castellated terminations
A.9 Example solder fillets and alignment: butt joints
A.10 Example solder fillets and alignment: inward L-shaped
flat ribbon leads
A.11 Example solder fillets and alignment: flat-lug leads on
power dissipating components
Figures
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.