MATERIALS FOR PRINTED BOARDS AND OTHER INTERCONNECTING STRUCTURES - PART 2-47: REINFORCED BASE MATERIALS CLAD AND UNCLAD - NON-HALOGENATED EPOXIDE NON-WOVEN/WOVEN E-GLASS REINFORCED LAMINATE SHEETS OF THERMAL CONDUCTIVITY (2.0W/M K) AND DEFINED FLAMMABILITY (VERTICAL BURNING TEST), COPPER-CLAD FOR LEAD-FREE ASSEMBLY

Published date

04-24-2018

Publisher

National Standards Authority of Ireland

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National foreword
FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Materials and construction
5 Electrical properties
6 Non-electrical properties of the copper-clad laminate
7 Non-electrical properties of the base material after
   complete removal of the copper foil
8 Quality assurance
9 Packaging and marking
10 Ordering information
Annex A (informative) - Engineering information
Annex B (informative) - Common laminate constructions
Annex C (informative) - Guideline for qualification and
        conformance inspection
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Provides requirements for properties of non-halogenated epoxide non-woven reinforced core/woven E-glass reinforced surface laminate sheets of thermal conductivity and defined flammability (vertical burning test), copper-clad for lead-free assembly in thicknesses of 0,60 mm up to 1,70 mm.

DevelopmentNote	For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (04/2018)
DocumentType	Standard
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN IEC 61249-2-47:2018	Identical

EN 61249-5-1:1996	Materials for interconnection structures - Part 5: Sectional specification set for conductive foils and films with or without coatings - Section 1: Copper foils (for the manufacture of copper-clad base materials)
IEC 61249-5-1:1995	Materials for interconnection structures - Part 5: Sectional specification set for conductive foils and films with and without coatings - Section 1: Copper foils (for the manufacture of copper-clad base materials)
ISO 14001:2015	Environmental management systems — Requirements with guidance for use
IEC 60194:2015	Printed board design, manufacture and assembly - Terms and definitions
ISO 11014:2009	Safety data sheet for chemical products Content and order of sections
ISO 9000:2015	Quality management systems — Fundamentals and vocabulary
IEC PAS 61249-6-3:2011	Specification for finished fabric woven from "E" glass for printed boards
IEC 61189-2:2006	Test methods for electrical materials, printed boards and other interconnection structures and assemblies - Part 2: Test methods for materials for interconnection structures
EN 61189-2:2006	Test methods for electrical materials, printed boards and other interconnection structures and assemblies - Part 2: Test methods for materials for interconnection structures