DIELECTRIC AND RESISTIVE PROPERTIES OF SOLID INSULATING MATERIALS - PART 2-1: RELATIVE PERMITTIVITY AND DISSIPATION FACTOR - TECHNICAL FREQUENCIES (0,1 HZ TO 10 MHZ) - AC METHODS

Published date

05-13-2018

Publisher

National Standards Authority of Ireland

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Method of test
5 Test procedure
6 Report
7 Repeatability and reproducibility
Annex A (informative) - Basic fundamentals
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications

Explains test methods for the determination of permittivity and dissipation factor properties of solid insulating materials (AC methods from 0,1 Hz up to 10 MHz).

DevelopmentNote	For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (05/2018)
DocumentType	Standard
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN IEC 62631-2-1:2018	Identical

IEC 62631-1:2011	Dielectric and resistive properties of solid insulating materials - Part 1: General
IEC 60212:2010	Standard conditions for use prior to and during the testing of solid electrical insulating materials
IEC 60250:1969	Recommended methods for the determination of the permittivity and dielectric dissipation factor of electrical insulating materials at power, audio and radio frequencies including metre wavelengths
ISO 294-3:2002	Plastics Injection moulding of test specimens of thermoplastic materials Part 3: Small plates
ISO 295:2004	Plastics — Compression moulding of test specimens of thermosetting materials
IEC 60216-4-1:2006	Electrical insulating materials - Thermal endurance properties - Part 4-1: Ageing ovens - Single-chamber ovens
EN 10088-2:2014	STAINLESS STEELS - PART 2: TECHNICAL DELIVERY CONDITIONS FOR SHEET/PLATE AND STRIP OF CORROSION RESISTING STEELS FOR GENERAL PURPOSES
IEC 60505:2011	Evaluation and qualification of electrical insulation systems
ISO 291:2008	Plastics Standard atmospheres for conditioning and testing
IEC 60050-121:1998	International Electrotechnical Vocabulary (IEV) - Part 121: Electromagnetism
ISO 294-1:2017	Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens
IEC 60247:2004	Insulating liquids - Measurement of relative permittivity, dielectric dissipation factor (tan d) and d.c. resistivity
IEC 60216-1:2013	Electrical insulating materials - Thermal endurance properties - Part 1: Ageing procedures and evaluation of test results
EN 60212:2011	Standard conditions for use prior to and during the testing of solid electrical insulating materials
ISO 558:1980	Conditioning and testing — Standard atmospheres — Definitions
ISO 4593:1993	Plastics Film and sheeting Determination of thickness by mechanical scanning