IEEE DRAFT 382 : D05 2006

Part I - Process
1 Overview
  1.1 Scope
  1.2 Purpose
2 Normative References
3 Definitions
4 Introduction
  4.1 General
  4.2 Requirements
5 Identification of the generic actuator group
  5.1 Generic actuator group identification
  5.2 Selection of actuator units for type testing
6 Qualification testing of selected actuators in generic
  actuator group
  6.1 Type test parameter values
  6.2 Type test plan
  6.3 Type test procedure
  6.4 Inspection
  6.5 Acceptance criteria
  6.6 Generic actuator group design modification
7 Qualification of actuator for specific application
  7.1 General
  7.2 Actuator specification
  7.3 Relationship to generic actuator group
  7.4 Relationship to specification
8 Documentation
  8.1 General
  8.2 Documentation for qualification of generic actuator group
  8.3 Documentation for qualification for a specific application
Part II - Tests
1 Baseline functional test
  1.1 Scope
  1.2 Test setup requirements
  1.3 Test conduct
2 Normal thermal aging test
  2.1 Scope
  2.2 Test setup requirements
  2.3 Test conduct
3 Normal radiation aging test
  3.1 Scope
  3.2 Test setup requirements
  3.3 Test conduct
4 Cycle aging test
  4.1 Scope
  4.2 Test setup requirements
  4.3 Test conduct
5 Vibration aging test
  5.1 Scope
  5.2 Test setup requirements
  5.3 Test conduct
6 Seismic simulation test
  6.1 Scope
  6.2 Test setup requirements
  6.3 Test conduct
7 DBE radiation exposure test
  7.1 Scope
  7.2 Test setup requirements
  7.3 Test conduct
8 Normal pressurization cycle test Error! Bookmark not defined
  8.1 Scope
  8.2 Test setup requirements
  8.3 Test conduct
9 DBE environment test
  9.1 Scope
  9.2 Test setup requirements
  9.3 Test conduct
Annex A (informative) Method of selection of representative
        actuator(s) for type testing
Annex B (informative) Rationale for vibration and seismic
        test methods
Annex C (informative) Performance verification test
Annex D (informative) Glossary
Annex E (informative) Bibliography