Name: NASA STD 6008(INT) : 2006
Brand: NASA

NASA STD 6008(INT) : 2006

Superseded

View Superseded by

NASA FASTENER MANAGEMENT AND CONTROL PRACTICES

Superseded date

07-11-2008

Published date

01-01-2006

Publisher

National Aeronautics and Space Administration

DOCUMENT HISTORY LOG
FOREWORD
1. SCOPE
   1.1 Purpose
   1.2 Applicability
2. APPLICABLE DOCUMENTS
3. ACRONYMS AND DEFINITIONS
   3.1 Acronyms
   3.2 Definitions
4. REQUIREMENTS
   4.1 Fastener Selection
   4.2 Approved Manufacturers and Distributors
   4.3 Receiving Inspection Screening
   4.4 Manufacturers' Test Report (MTR)
   4.5 Certificate of Conformance
   4.6 Traceability
        4.6.1 Partial Traceability
        4.6.2 Storage
   4.6 Specialized Fasteners
   4.7 Audits
   4.8 Specialized Fasteners
   4.9 Mission-Critical Fasteners
   4.10 Low-Released Mass, Contained Fastener, and
        Low-Risk Fracture Fasteners
   4.11 Commercial-Off-The-Shelf (COTS) Hardware
   4.12 Deviations/Waivers from this Requirement
   4.13 Quality Assurance Provisions
        4.13.1 Discrepant/Nonconformant Fasteners
        4.13.2 Certification Validation Tests (CVT)
               and Screening Inspections
        4.13.3 Visual Inspection
        4.13.4 Tensile Test
        4.13.5 Nondestructive Evaluation (NDE)
        4.13.6 Dimensional Inspection
        4.13.7 Hardness Test
        4.13.8 Proof Test
        4.13.9 Chemical/Elemental Analysis
5. GUIDANCE
   5.1 Reference Documents
   5.2 Government Documents
        5.2.1 Specifications, Standards, and Handbook
   5.3 Non-Government Documents

Establishes fastener management and control policy, responsibilities, and practices for all fasteners used for space flight hardware and ground support equipment (GSE) that are procured, received, tested, inventoried, or installed for space flight by a NASA Center, prime contractors, or hardware developers.

DevelopmentNote	Expires 11 Sept 2007. (10/2006)
DocumentType	Standard
PublisherName	National Aeronautics and Space Administration
Status	Superseded
SupersededBy	NASA STD 6008 : 2008 CHANGE 1 2013

NASA STD 6016(INT) : 2006	STANDARD MATERIALS AND PROCESSES REQUIREMENTS FOR SPACECRAFT
NASA STD 5005(INT) : 2007	THE DESIGN AND FABRICATION OF GROUND SUPPORT EQUIPMENT

NASA STD 8719.9 : 2015	LIFTING STANDARD
NASA STD 5001 : 2014	STRUCTURAL DESIGN AND TEST FACTORS OF SAFETY FOR SPACEFLIGHT HARDWARE
NASA STD 5003 : 0	FRACTURE CONTROL REQUIREMENTS FOR PAYLOADS USING THE SPACE SHUTTLE
NAM 1312/108 : REV 1	FASTENER TEST METHODS, METRIC METHOD 108 TENSILE STRENGTH
ASTM E 1086 : 2014 : REDLINE	Standard Test Method for Analysis of Austenitic Stainless Steel by Spark Atomic Emission Spectrometry
NASM 1312-8 : 2001	FASTENER TEST METHODS, METHOD 8, TENSILE STRENGTH