• There are no items in your cart

PREN 13205 : DRAFT 2010

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

WORKPLACE EXPOSURE - ASSESSMENT OF SAMPLER PERFORMANCE FOR MEASUREMENT OF AIRBORNE PARTICLE CONCENTRATIONS
Superseded date

10-01-2012

Published date

01-12-2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Requirements
6 Test methods
7 Types of evaluation
8 Instructions for use
9 Marking, quality control
Annex A (normative) - Laboratory performance test,
        based on determination of sampling efficiency
        and modelling of concentrations determined by
        sampling
Annex B (normative) - Laboratory performance test,
        based on comparison of concentrations determined
        with the candidate sampler and a validated sampler
Annex C (normative) - Workplace performance test,
        based on comparison of concentrations determined
        with the candidate sampler and a validated sampler
Annex D (informative) - Recommended procedure
        for a workplace comparison of a candidate sampler
        and a validated sampler in order to obtain a
        correction factor
Annex E (normative) - Transport test based on
        weighing samples before and after shipping
        by mail
Annex F (normative) - Handling test for loaded
        samplers or collection substrates using
        a shaker
Annex G (normative) - Calculation of expanded
        uncertainty for a measurement procedure
Annex H (informative) - Analysis of sampling
        efficiency data from a performance test according
        to Annex A
Bibliography

Describes methods for testing aerosol samplers under prescribed laboratory conditions, and performance requirements that are specific to aerosol samplers. These performance requirements, which include conformity with the EN 481 sampling conventions, apply only to the process of sampling the airborne particles from the air, not to the process of analyzing particles collected by the process of sampling. Although analysis of samples collected in the course of testing is usually necessary in order to evaluate the sampler performance, the specified test methods ensure that analytical errors are kept very low during testing and do not contribute significantly to the end result. The determination of analytical errors and factors related to them (for example the bias, precision and limit of detection of the analytical method) is outside the scope of this standard. Where the aerosol sampler requires the use of an external (rather than integral) pump, the pump is not subject to the requirements of this standard.

Committee
TC 137
DevelopmentNote
Superseded by PREN 13205-1, PREN 13205-2, PREN 13205-4, PREN 13205-5 and PREN 13205-6 but remains current. (10/2012)
DocumentType
Draft
PublisherName
Comite Europeen de Normalisation
Status
Superseded
SupersededBy

Standards Relationship
11/30228336 DC : 0 Identical

13/30231417 DC : 0 BS ISO 16258-2 - WORKPLACE AIR - RESPIRABLE CRYSTALLINE SILICA BY X-RAY DIFFRACTION - PART 2: METHOD BY INDIRECT ANALYSIS
DD ENV 13936:2001 Workplace atmospheres. Measurement of chemical agents present as mixtures of airborne particles and vapour. Requirements and test methods
ASTM D 6552 : 2006 : R2016 Standard Practice for Controlling and Characterizing Errors in Weighing Collected Aerosols
ASTM D 6552 : 2006 : R2011 Standard Practice for Controlling and Characterizing Errors in Weighing Collected Aerosols
ENV 13936 : DRAFT 2001 WORKPLACE ATMOSPHERES - MEASUREMENT OF CHEMICAL AGENTS PRESENT AS MIXTURES OF AIRBORNE PARTICLES AND VAPOUR - REQUIREMENTS AND TEST METHODS
ASTM D 6552 : 2006 Standard Practice for Controlling and Characterizing Errors in Weighing Collected Aerosols

EN 14530:2004 Workplace atmospheres - Determination of diesel particulate matter - General requirements
EN 12919:1999 Workplace atmospheres - Pumps for the sampling of chemical agents with a volume flow rate of over 5 l/min - Requirements and test methods
ISO 24095:2009 Workplace air Guidance for the measurement of respirable crystalline silica
EN 481:1993 Workplace atmospheres - Size fraction definitions for measurement of airborne particles
EN 482:2012+A1:2015 Workplace exposure - General requirements for the performance of procedures for the measurement of chemical agents
EN 13890:2009 Workplace exposure - Procedures for measuring metals and metalloids in airborne particles - Requirements and test methods
ISO 21438-3:2010 Workplace atmospheres — Determination of inorganic acids by ion chromatography — Part 3: Hydrofluoric acid and particulate fluorides
ISO 3534-2:2006 Statistics Vocabulary and symbols Part 2: Applied statistics
ISO 21438-1:2007 Workplace atmospheres Determination of inorganic acids by ion chromatography Part 1: Non-volatile acids (sulfuric acid and phosphoric acid)
EN 143:2000/A1:2006 RESPIRATORY PROTECTIVE DEVICES - PARTICLE FILTERS - REQUIREMENTS, TESTING, MARKING
EN 1232:1997 Workplace atmospheres - Pumps for personal sampling of chemical agents - Requirements and test methods
ISO 15767:2009 Workplace atmospheres Controlling and characterizing uncertainty in weighing collected aerosols

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.