SN EN 1011-2 : 2001 AMD 1 2004

Foreword<br>Introduction<br>1 Scope<br>2 Normative references<br>3 Terms and definitions<br>4 Symbols and abbreviations<br>5 Parent metal<br>6 Weldability factors<br>7 Handling of welding consumables<br>8 Weld details<br>9 Welds in holes or slots<br>10 Preparation of joint face<br>11 Alignment of butt welds before welding<br>12 Preheating<br>13 Tack welds<br>14 Temporary attachments <br>15 Heat input<br>16 Welding procedure specification<br>17 Identification<br>18 Inspection and testing<br>19 Correction of non-conforming welds<br>20 Correction of distortion<br>21 Post weld heat treatment<br>Annex A (informative) Possible detrimental phenomena <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;resulting from welding of steels, not covered by<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;other annexes<br>Annex B (informative) Guidance on joint detail design<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;(when there is no application standard)<br>Annex C (informative) Avoidance of hydrogen cracking <br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;(also known as cold cracking)<br>Annex D (informative) Heat affected zone toughness and<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;hardness<br>Annex E (informative) Avoidance of solidification<br>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;cracking<br>Annex F (informative) Avoidance of lamellar tearing<br>Annex G (informative) References in the annexes<br>Bibliography