TS 100 718 : 1.1.1

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
3 Definitions, abbreviations and symbols
   3.1 Definitions
   3.2 Abbreviations
   3.3 Symbols
4 General
   4.1 Presentation of equipment for testing
   4.2 Mechanical and electrical design
   4.3 Interpretation of the measurement results
5 Test conditions, power sources and ambient
   temperatures
   5.1 Normal and extreme test conditions
   5.2 External test power source
   5.3 Normal test conditions
   5.4 Extreme test conditions
6 General conditions
   6.1 Normal test signals
   6.2 Test fixture
   6.3 Test sites and general arrangements for
       radiated measurements
   6.4 Measuring receiver
7 Environmental tests
   7.1 Procedure
   7.2 Drop test on hard surface
   7.3 Temperature tests
   7.4 Immersion test
   7.5 Solar radiation
   7.6 Tensile test
8 Methods of measurement and limits for transmitter
   parameters
   8.1 Modulation and carrier keying
   8.2 Frequency error
   8.3 Output field strength (H-field)
   8.4 Spurious emissions
9 Methods of measurement and limits for receiver
   parameters
   9.1 Receiver sensitivity
   9.2 Changes in the received signal
10 Measurement uncertainty
Annex A (normative): Radiated measurements
A.1 Test sites and general arrangements for
        measurements involving the use of radiated
        fields
A.2 Guidance on the use of radiation test sites
A.3 Further optional alternative indoor test site
        using an anechoic chamber
Annex B (normative): Spurious limits, H-field
        at 10 m distances
Annex C (normative): Simulated solar radiation
        source
Annex D (informative): E-fields in the near field
        at low frequencies
History