09/30158428 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
08-31-2011
English
FOREWORD
1 Scope
2 Normative references
3 Definitions
4 Parameter measurement tolerances
5 Cell designation and marking
5.1 Cell designation
5.1.1 Small prismatic cells and cylindrical cells
5.1.1.1 Small prismatic cells
5.1.1.2 Cylindrical cells
5.1.2 Button cells
5.2 Cell termination
5.3 Marking
5.3.1 Small prismatic cells and cylindrical cells
5.3.2 Button cells
6 Dimensions
6.1 Small prismatic cells and cylindrical cells
6.1.1 Small prismatic cells
6.1.2 Cylindrical cells
6.1.2.1 Cells dimensionally interchangeable
with primary cells
6.1.2.2 Cells not dimensionally interchangeable
with primary cells
6.2 Button cells
7 Electrical tests
7.1 Charging procedure for test purposes
7.2 Discharge performance
7.2.1 Discharge performance at 20 degree C
7.2.2 Discharge performance at 0 degree C
7.2.3 Discharge performance for rapid charge
cells (R cells)
7.3 Charge (capacity) retention
7.4 Endurance
7.4.1 Endurance in cycles
7.4.1.1 Small prismatic, button and cylindrical
cells not dimensionally interchangeable
with primary cells
7.4.1.2 Cylindrical cells dimensionally
interchangeable with primary cells
7.4.1.3 Cylindrical cells (accelerated test
procedures)
7.4.2 Permanent charge endurance
7.4.2.1 Small prismatic and button cells
7.4.2.2 L, M, H or X cylindrical cells
7.4.2.3 LT, MT or HT cylindrical cells
7.4.2.4 LU, MU or HU cylindrical cells
7.5 Charge acceptance at constant voltage
7.6 Overcharge
7.6.1 Small prismatic, L, M, H, X, LS or MS cylindrical,
and button cells
7.6.2 LT/LU, MT/MU or HT/HU cylindrical cells
7.6.3 R cylindrical cells
7.7 Safety device operation
7.8 Surface temperature limitation device operation
(for S cell only)
7.9 Storage
7.10 Charge acceptance at +55 degree C for LT, MT or HT
cylindrical cells
7.11 Internal resistance
7.11.1 Measurement of the internal a.c. resistance
7.11.2 Measurement of the internal d.c. resistance
8 Mechanical tests
9 Safety requirements
10 Type approval and batch acceptance
10.1 Type approval
10.1.1 Type approval for small prismatic cells
and button cells
10.1.2 Type approval for cylindrical cells
10.2 Batch acceptance
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.