Foreword
Introduction
1 Scope
2 Normative references
3 Definitions and abbreviations
  3.1 Definitions
  3.2 Abbreviated terms
4 System requirements
  4.1 General
  4.2 Radio frequency transmission paths
       4.2.1 Immunity to site attenuation
       4.2.2 Alarm signal integrity
       4.2.3 Identification of components
       4.2.4 Receiver performance
       4.2.5 Immunity to interference
       4.2.6 Loss of communication
       4.2.7 Antenna
5 Components requirements
  5.1 Compliance
  5.2 General
  5.3 Power supply equipment
  5.4 Environmental
       5.4.1 General
       5.4.2 General test procedure
       5.4.3 Provision for testing
6 Marking
7 Data
  7.1 General
  7.2 Input/output devices
8 Tests
  8.1 General requirements
       8.1.1 General
       8.1.2 Standard atmospheric conditions for testing
       8.1.3 Operating conditions for tests
       8.1.4 Mounting and orientation
       8.1.5 Tolerances
  8.2 System tests
       8.2.1 Test schedule for system tests
       8.2.2 Immunity to site attenuation
       8.2.3 Alarm signal integrity
       8.2.4 Identification of components with r.f.
              transmission path
       8.2.5 Receiver performance
       8.2.6 Mutual disturbance between systems
              of the same manufacturer
       8.2.7 Compatibility with other band users
       8.2.8 Detection of a loss of communication
              on a r.f. transmission path
       8.2.9 Antenna
  8.3 Components tests
       8.3.1 General
       8.3.2 Test schedule for components tests
       8.3.3 Verification of the service life of the
              autonomous power source(s)
       8.3.4 Low power condition fault signal
       8.3.5 Polarity reversal
       8.3.6 Repeatability
       8.3.7 Reproducibility
       8.3.8 Variation of supply parameters
       8.3.9 Dry heat (operational)
       8.3.10 Dry heat (endurance)
       8.3.11 Cold (operational)
       8.3.12 Damp heat, cyclic (operational)
       8.3.13 Damp heat, steady state (operational)
       8.3.14 Damp heat, steady state (endurance)
       8.3.15 SO2-corrosion (endurance)
       8.3.16 Shock (operational)
       8.3.17 Impact (operational)
       8.3.18 Vibration, sinusoidal (operational)
       8.3.19 Vibration, sinusoidal (endurance)
       8.3.20 Electromagnetic Compatibility (EMC),
              Immunity tests (operational)
Annex A (normative) - Test configuration by using radio
        frequency shielded test equipment
  A.1 Radio frequency shielded test equipment for
       the component or the radio part of the
       component transmitting the alarm signal
  A.2 Radio frequency shielded test equipment for
       the component or the radio part of the
       component receiving the alarm signal
  A.3 Cable connection between test equipment with
       component transmitting the alarm signal
       and test equipment with component receiving the
       alarm signal
  A.4 Determination of the transmission threshold A
Annex B (normative) - Immunity to site attenuation (path loss)
Annex C (informative) - Data and calculation of the service
        life of the autonomous power source(s)