1 Scope
2 Normative references
3 Terms and definitions
  3.1 Description
  3.2 Loads
  3.3 Friction torque under load at ambient temperature
  3.4 Surface discontinuities
  3.5 Adhesion of the liner
4 Required characteristics, inspection and test methods
5 Quality assurance
  5.1 Manufacturer's approval
  5.2 Product qualification
6 Acceptance conditions
  6.1 Manufacturer's responsibility
  6.2 Inspections and tests to be carried out by the
      manufacturer
  6.3 Customer quality control
7 Packaging
8 Certificate of compliance
Annex A (normative) - Testing of permissible and ultimate
        static loads
  A.1 Permissible radial static loads (C[s])
      A.1.1 Principle
      A.1.2 Method
  A.2 Ultimate radial static loads
      A.2.1 Principle
      A.2.2 Method
  A.3 Permissible axial static loads (C[a])
      A.3.1 Principle
      A.3.2 Method
  A.4 Ultimate axial static loads
      A.4.1 Principle
      A.4.2 Method
Annex B (normative) - Testing of permissible radial dynamic
        loads (C[25])
  B.1 Principle
  B.2 Method
      B.2.1 Test to be carried out at ambient temperature
      B.2.2 Test to be carried out at low temperature
      B.2.3 Test to be carried out at high temperature
      B.2.4 Test to be carried out at ambient temperature
            following immersion
Annex C (normative) - Fluids - Essential characteristics
  C.1 Fuel for turbine aero engine
  C.2 Fluids for de-icing circuit
  C.3 Hydraulic fluids
      C.3.1 Mineral fluid for hydraulic transmission
      C.3.2 Phosphate of ester hydraulic fluid
  C.4 De-icing and anti-icing fluids
Annex D (normative) - Resistance of the liner to peeling
  D.1 Principle
  D.2 Method
Annex E (for inch size only) (normative) - Measurement of
        friction coefficient for EN 4534-2, EN 4535-2,
        EN 4536-2 and EN 4537-2
  E.1 Principle
  E.2 Starting torque under load C25 at room temperature
      E.2.1 General
      E.2.2 Method
Annex F (informative) - Permissible unit pressure