10/30237537 DC : 0

Superseded

EN 15383 - PLASTICS PIPING SYSTEMS FOR DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON POLYESTER RESIN (UP) - MANHOLES AND INSPECTION CHAMBERS

Available format(s)

Hardcopy , PDF

Superseded date

01-31-2013

Language(s)

English

Publisher

British Standards Institution

1 Scope
2 Normative references
3 Definitions and symbols
4 General requirements
5 Geometrical characteristics
6 Mechanical characteristics
7 Leak-tightness of manholes and inspection
   chambers and their joints
8 Marking
9 Ancillary products
10 Dangerous substances
11 Manufacturer's installation recommendations
12 Evaluation of conformity
Annex A (normative) - Determination of the
        longitudinal compressive properties measured
        on prism shaped test pieces
Annex B (normative) - Determination of the
        compressive stress and, if required strain, up
        to break using spool test pieces
Annex C (normative) - Determination of the
        resistance of installed steps to vertical or
        horizontal loading
Bibliography

EN 15383

Committee	PRI/88/2
DocumentType	Draft
Pages	40
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS EN 15383 : 2012

EN 14396:2004	Fixed ladders for manholes
ISO 7685:1998	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of initial specific ring stiffness
EN 761:1994/AC:1995	PLASTICS PIPING SYSTEMS - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) PIPES - DETERMINATION OF THE CREEP FACTOR UNDER DRY CONDITIONS
ISO 10928:2016	Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use
EN ISO 604 : 2003	PLASTICS - DETERMINATION OF COMPRESSIVE PROPERTIES (ISO 604:2002)
CEN/TS 14632:2012	Plastics piping systems for drainage, sewerage and water supply, pressure and non-pressure - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Guidance for the assessment of conformity
EN 1917:2002/AC:2008	CONCRETE MANHOLES AND INSPECTION CHAMBERS, UNREINFORCED, STEEL FIBRE AND REINFORCED
ISO 2602:1980	Statistical interpretation of test results Estimation of the mean Confidence interval
EN 476:2011	General requirements for components used in drains and sewers
ISO 2078:1993	Textile glass Yarns Designation
ISO 10466:1997	Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Test method to prove the resistance to initial ring deflection
EN 124:1994	Gully tops and manhole tops for vehicular and pedestrian areas - Design requirements, type testing, marking, quality control
ISO 604:2002	Plastics — Determination of compressive properties
EN 13101:2002	Steps for underground man entry chambers - Requirements, marking, testing and evaluation of conformity
EN 14364:2013	Plastics piping systems for drainage and sewerage with or without pressure - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Specifications for pipes, fittings and joints
ENV 1046:2001	Plastics piping and ducting systems - Systems outside building structures for the conveyance of water or sewage - Practices for installation above and below ground