11/30199264 DC : 0

Superseded

View Superseded by

BS ISO 13106 - PLASTICS - BLOW-MOULDED POLYPROPYLENE CONTAINERS FOR PACKAGING OF LIQUID FOODSTUFFS

Available format(s)

Hardcopy , PDF

Superseded date

05-31-2014

Language(s)

English

Publisher

British Standards Institution

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Capacity
5 Container mass - tare weight
6 Raw material
7 Tolerance on dimensions
8 Requirement
9 Marking
10 Sampling & criterion for conformity
Annex A (normative) - NECK HEIGHT DETERMINATION
Annex B (normative) - NECK FINISH DIMENSIONS
Bibliography

BS ISO 13106.

Committee	PRI/75
DocumentType	Draft
Pages	17
PublisherName	British Standards Institution
Status	Superseded
SupersededBy	BS ISO 13106:2014

BS 1918-2:1981	Glass container finishes Specification for crown finish
ISO 15270:2008	Plastics — Guidelines for the recovery and recycling of plastics waste
ISO 22088-1:2006	Plastics Determination of resistance to environmental stress cracking (ESC) Part 1: General guidance
ISO 1873-2:2007	Plastics Polypropylene (PP) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties
BS 1918-1:1978	Glass container finishes Specification for continuous thread finish
BIS IS 10909 : 2001(R2015)	POSITIVE LIST OF CONSTITUENTS OF POLYPROPYLENE AND ITS COPOLYMERS IN CONTACT WITH FOODSTUFFS, PHARMACEUTICALS AND DRINKING WATER
ISO 1873-1:1995	Plastics Polypropylene (PP) moulding and extrusion materials Part 1: Designation system and basis for specifications
ISO 11469:2016	Plastics — Generic identification and marking of plastics products
ASTM D 2659 : 2016 : REDLINE	Standard Test Method for Column Crush Properties of Blown Thermoplastic Containers
BS 4839-1:1972	Plastics containers Containers up to 5 litres capacity
BIS IS 10910 : 1984(R1997)	SPECIFICATION FOR POLYPROPYLENE AND ITS COPOLYMERS FOR ITS SAFE USE IN CONTACT WITH FOODSTUFFS, PHARMACEUTICALS AND DRINKING WATER
BIS IS 2798 : 1998 AMD 2 2009	METHODS OF TEST FOR PLASTICS CONTAINERS
ISO 9113:1986	Plastics Polypropylene (PP) and propylene-copolymer thermoplastics Determination of isotactic index
ASTM D 5857 : 2017 : REDLINE	Standard Specification for Polypropylene Injection and Extrusion Materials Using ISO Protocol and Methodology
BIS IS 10951 : 2002	POLYPROPYLENE MATERIALS FOR MOULDING AND EXTRUSION
ISO 1043-1:2011	Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics